Every safety recall published by the Australian government, searchable and filterable.
The transmission oil cooler lines below the transmission may crack under certain circumstances. Should this occur, transmission oil may leak on to the road and pose a hazard to ot…
The affected vehicles windshield may not be chemically bonded to the Polyurethane (PU) adhesive. Where the windshield is not chemically bonded, water ingress may occur and there ma…
A concern has been identified with corrosion to brake pipes at the junction between the twin under floor pipes and the rear cross member pipes fitted to 2003 and certain 2004 MJ XJ…
The foot peg pivot pin may bend due to insufficient hardness of the metal.
The side indicator lights on the front fenders do not comply with current Australian Design Rules for lateral visibility.
When examining the clamping joint on the track rod and drag link, defects in tolerances and corrosion have been found.
The previous software upgrade for the engine control unit may not fully overcome the possibility of piston damage occurring as a result of a less than ideal combustion process. If…
A concern has been detected relating to the engine air intake duct which may become disconnected due to thermal loading combined with normal engine vibration. If this happens, the…
Volvo Car Corporation have identified that the engine cooling fan may permanently stop working due to a software error in the Fan Control Module (FCM). If the fan stops it may caus…
The engine air intake duct may become disconnected due to thermal loading combined with normal engine vibration. If this happens, the engine will exhibit rough idling and in a wors…
There have been instances where the screw for the brake pedal's mounting has not been fully engaged in its flange nut.
The engine air intake duct may become disconnected due to thermal loading combined with normal engine vibration. If this happens, the engine will exhibit rough idling and in a wors…
In certain high speed, high engine RPM situations foaming can develop in the front brake master cylinder reservoir.
The Ohlins RH front fork leg may feature a flaw, which could result in safety problems, especially in case of misuse of the motorcycle.
The brake booster check valve may develop a vacuum leak.
The brake booster check valve may develop a vacuum leak.
The turbo heat shield mounting could break and cause the steering shaft to jam; this may require extra effort to turn the vehicle
Harley-Davidson Motor Company, Inc. has determined that some of these model motorcycles may have been shipped with an incorrect Australian Noise Label part number 14000-07. The lab…
After investigation it was found that due to poor fitment of the oil seal (Gap between the oil seal and needles in the bearing cap) there were some bearing caps where it is possibl…
Front-wheel quick-release axles that are not in compliance with design specifications might be installed in some motorcycles.Due to irregularities in the manufacturing process, in…
Front-wheel quick-release axles that are not in compliance with design specifications might be installed in some motorcycles.Due to irregularities in the manufacturing process, in…
Possible cracking on the corners of the coupling plate on the A frame.
When examining the clamping joint on the track rod, defects in tolerances and corrosion have been found.
Under certain conditions, the supply of vacuum to the brake booster may be interrupted. The consequences are possible hard brake pedal with increased stopping distances.
It is possible that the incorrectly specified power steering pump may have been fitted during production. In rare cases this may cause some stiffness in the operation of the steeri…