Australia's fastest vehicle recall check. Enter your VIN to see if any safety recalls apply. Free, no account, no spam.
Due to a manufacturing issue, some of the cell modules installed in the high voltage battery may overheat at high charge levels. If this occurs, it could lead to a vehicle fire.Not…
Due to a software issue with the high-voltage battery Electronic Control Unit, the electric drive system may shut down. This could lead to a loss of motive power resulting in “EV S…
Due to a software issue with the high-voltage battery Electronic Control Unit, the electric drive system may shut down. This could lead to a loss of motive power resulting in “EV S…
Due to a manufacturing defect, the hydraulic jack in the brush chipper may extend without input from the operator. If this occurs while the vehicle is being towed, it could result…
Due to a manufacturing defect, the brake pipe may chafe against the engine and become damaged. This could lead to a brake fluid leak resulting in reduced braking performance.
Due to a manufacturing defect, the Front Underrun Protection System (FUPS) fitted to affected vehicles may have ground clearance that exceeds the compliance standard.
Due to a software issue, the Instrument Panel Cluster (IPC) may fail to illuminate the visual vehicle speed, fuel level and other critical safety information.
Due to a manufacturing defect, the shaft in the three-way valve may break and lead to a coolant leak. This may cause the valve connector to overheat and result in loss of motive po…
Due to a manufacturing defect, the low-pressure fuel pump may not operate as intended and could result in the check engine and master warning indicators to illuminate on the combin…
Due to a manufacturing defect, the lock stops on the 24V battery tray frame are missing. As a result, the tray may detach and fall when pulled out during maintenance work.
Due to a manufacturing defect, the rear centre seat belt anchor buckle may not meet specifications. As a result, the seat belt may not properly latch or operate as intended.
On certain UD Trucks, the rear axle lock washer may dislodge and chafe against the hub cover. If this occurs, it could generate metal powder, causing bearing seizure, abnormal nois…