Every safety recall published by the Australian government, searchable and filterable.
1. Water ingress past the 'O' ring seal possibly causing corrosion on electrical contacts and possible failure of the fuel pump.2. There is a possibility that if work is undertaken…
1. Water ingress past the 'O' ring seal possibly causing corrosion on electrical contacts and possible failure of the fuel pump.2. There is a possibility that if work is undertaken…
Intermittent hard starting/stalling problems and the illumination of the engine check light.
The triggering of the front airbags may not meet legal requirements.
The bolt of the Steering Damper is not tightened sufficiently by the assembly operation error. There is a possibility that the bolt loosens and the Steering Damper comes detached f…
A possibility exists that if the front seat belts are extended quickly with strong force, the internal components of the Emergency Locking Retractor (ELR) may jam and the seat belt…
There is a possibility that the seat belts fitted to the passenger seats may become frayed and damaged on the unprotected metal frame of the seat backing.
If the air bag is inflated in very cold conditions, there is a possibility that the horn bolt could fracture, causing the horn switch components to be scattered.
In the airbag system of the subject vehicles, due to Incorrect assembly process of the airbag inflator, which is used in the curtain sheild airbag and the knee airbag systems, some…
Excessive play on rear LH and RH seatbelt stalk fastener. This does not have any impact on the efficiency of the seatbelt. In exceptional cases however it may eventually cause loos…
R0511: In the enent of certain frontal collisions, the Outer Rear Seat Belt webbing can contact the Rear Seat Back Hinge, and there is a possibility it can be cut by the sharp edge…
R0511: In the enent of certain frontal collisions, the Outer Rear Seat Belt webbing can contact the Rear Seat Back Hinge, and there is a possibility it can be cut by the sharp edge…
Sudden vehicle movement in a forward or reverse direction could be experienced if the accelerator pedal is pressed.
The sunroof glass has been incorrectly manufactured. It is possible on door closure, severe road impact or when operated that the sunroof glass may shatter.
Possibility that under certain conditions the trailer can lean to one side.
Cars were supplied from the manufacturer without the required third child restraint anchorage bracket fitted to the split rear seat backrest, thereby contravening the relevant ADR.
The ignition switch lead wire may be damaged by rubbing due to being routed too tightly. This may cause a short circuit which in turn could cause the engine to stall.
The mudguard does not comply with the Australian Design Rules and the use of the vehicle may potentially cause damage by the flicking of stones from the rear of the tyre.
There is a possibility that the pinch bolt is not correctly tensioned on the upper end of the steering column and/or the splined column shaft is not fully inserted into the female…
Rare occurence of the inadvertent operation of the starter motor.
Moisture may penetrate the steering shaft in your Mercedes-Benz truck.
A notching effect may be present in the left or right side wiper arm which could in turn weaken it. A possible consequence is that the arm may fracture when placed under high loads…
Some vehicles are fitted with an incorrect scissor style jack.
A possibility exists that the parking brake cable lock nut may not have been correctly tightened during the vehicle assembly process. This condition may lead to loosening of the ad…
A fatigue crack may develop on the Steering Relay Rod. The crack may occur if the steering wheel is repeatedly turned under certain conditions where high steering effort is require…