Every safety recall published by the Australian government, searchable and filterable.
Investigations have shown that the front door latch cables may become unseated from the interior release handle housing under certain conditions. This could cause the door latch ha…
In some circumstances ingress of water into the carburettor throttle body may occur due to rain or pressure washing. The water may freeze and cause the throttle to have sluggish re…
Cracks may develop in the steering idler arm after an extended period of operation. In an extreme case, a cracked steering idler arm may break without warning and cause a loss of s…
Die to fatigue a crack may develop in the brazed portion of the air vent pipe in the bottom of the fuel tank, resulting in fuel leakage.
Due to the deterioration with age of the tubeless valves fitted to the front and rear wheels, the rubber may lose its sealing ability, resulting in the gradual or rapid loss of tyr…
The climate control system may have limited operation after engine start up. In these instances there may be no defroster operation.
Failure of the number plate holder support.
The engine installed in affected vehicles may be fitted with a front end accessory drive belt that could delaminate and result in premature failure.
If the independent trailer handpiece is actuated while the vehicle is in cruise control, the cruise control will not cutout and the engine will continue driving. After the trailer…
Engine stalls at idle, which could endanger rider safety. Problem to be fixed by downloading new software to the engine control unit.
Depending on the axle and suspension type, specific vans that have been manufactured by Jayco Corporation Pty Ltd may require a change to the jacking point of the van.
Investigations have shown that the EBC module may have been programmed with an incorrect software version. It is possible under certain conditions that a momentary delay in braking…
During the manufacture of two fuel pipes located on the engine's fuel delivery manifold, high stress areas may have been created in the pipes. Combined with other factors such as c…
The front edge of the older design genuine accessory carpet mat overlaps the arc of travel of the accelerator pedal. This creates the potential for interference of the carpet mat w…
A limited number of trucks have an incorrectly welded fluid coupling.
A potential problem exists with restricted lateral movement of the sliding carriage of the fitted top rack, which could lead to reduced stability of the motorcycle if ridden at spe…
A number of NS Pajero vehicles have been manufactured with the incorrect nuts used to retain the front R/H drive shaft and both front and rear propeller shafts. The threaded portio…
A potential fault in the glow plug relay, which is part of the engine pre-heating system, may cause the coil to overheat and possibly short circuit.
In certain circumstances the underhood speed control deactivation switch mounted on the brake master cylinder may leak and brake fluid contamination in the electrical connector may…
The air pressure warning light (equipped with as Visible Indicator regulated in ADR 35/01 S.5.2') was not so designed that, as a check of function, it operates when the ignition ke…
There is a possibility that an incorrect tightening of the muffler mounting bolts may cause the bolts to unscrew by vibration, which may result in the muffler falling off and creat…
In isolated instances, fuel lines suffered incipient damage in the course of the manufacturing process. Lines damaged in this way could develop leaks soon after customers start usi…
Some G650 Xchallenge motorcycles left the factory with the wrong circlip installed on the left-hand side of the rear wheel-bearing guide. The result can be that this circlip rubs a…
Certain Douglas Autotech steering columns may have been manufactured without two welds which could cause the column to fatigue and fracture over time, thereby allowing the steering…
Investigations by the manufacturer have shown that there is a possibility the thread profile for the rear axle hub retaining nut may be out of specification, thereby decreasing the…