Every safety recall published by the Australian government, searchable and filterable.
The airline routing may cause excessive load on the VIPS connections causing the brakes to lock on.
A bug in the electronic software.
There have been instances where the thread between the nut and the bolt for the clamp for the track rods ball joint has been cut during tightening in production. The reason for thi…
A manufacturing fault has occurred in some battery isolation switches that allows some current flow through the switch when in an isolated state.
Possibility of counterweight falling down while driving on the road. Failure occurs in loosing the tightening torque of the mounting bolts for counterweight.
Vehicles may have sustained damage to the steering column upper universal joint during the shipping process to the vehicle production plant.
Under certain operating conditions it is possible that the HVAC blower motor could overheat and, in an extreme case, may even ignite.
Investigations have revealed that a windowbag with a defective gas diffuser may have been installed in the vehicle and must be replaced. The diffuser connects the gas generator to…
Investigations have revealed that a windowbag with a defective gas diffuser may have been installed in the vehicle and must be replaced. The diffuser connects the gas generator to…
The battery can move in its housing in the fuel tank and this could result in main wiring harness cables damage at the battery terminals.
Investigations have revealed that a windowbag with a defective gas diffuser may have been installed in the vehicle and must be replaced. The diffuser connects the gas generator to…
On Caddy vehicles of the affected chassis number ranges the spring clamps on the rear axle may break because of poor heat treatment.
Investigations have shown that the Totally Integrated Power Module was programmed with incorrect software that may allow the engine to stall under certain operating conditions.
To check that the layout of the fuel supply pipe from the diesel filter to the high pressure pump is correct to prevent possible interference between the actual pipe and the fuel f…
The sensor on the gearbox is not sealed correctly.
There is a possibility that the bolt welded to the manual control lever (mounted on the automatic transmission) may develop a crack when the shift cable attaching nut is tightened.…
Due to a manufacturing fault in the Bendix SR-7 modulating spring brake valve housing, air could intermittently enter the spring brake when the parking brake is applied instead of…
Investigations have revealed that corrosion in the steel braiding of an ABC hydraulic hose may occur over time when exposed to moisture and heat. This could in turn lead to oil lea…
To check that the layout of the fuel supply pipe from the diesel filter to the high pressure pump is correct to prevent possible interference between the actual pipe and the fuel f…
A bolt securing the engine and transmission assembly to one of its mounting points may loosen over time. In the worst case scenario, if the bolt comes out or breaks, the engine and…
Due to insufficient protection material applied to the instrument panel bracket edges, the cab wiring harness may rub and short circuit at the instrument panel fuse box.
Engineering investigations have identified a concern with the front suspension strut to knuckle clamping bolt torque. Due to variations in surface finish of the knuckle material in…
The vehicles fitted with 'Cantilever' suspension may experience breaking of the rear suspension bracket retaining bolts. This bracket is used to mount the rear shock absorber as we…
The tyre may be prone to failure including tread-belt separation.
A possible defect in the tread due to a manufacturing irregularity.