Every safety recall published by the Australian government, searchable and filterable.
The recall relates to a Trailer with Electronic Braking System (EBS) when connected the trailer warning light will not be activated. However, the braking functionality is not affe…
A possible defect exists due to the possibility that the trunk harness may become damaged, causing an open circuit and either resulting in the loss of the license plate lamp, rever…
Affected vehicles will be recalled to inspect that the rear subframe fixing is correctly fitted and clamped up.
It is possible that a small percentage of the tyres may experience belt detachment, especially if operated below recommended inflation pressures for the load carried by the tyre or…
Safety recall to check and, if necessary, replace the front suspension pivot(s) and pivot ball joint(s). This action is necessary to eliminate the risk of a vehicle trajectory out…
The engine was assembled with incorrect air cleaner cap and engine control computers. As a result the vehicle does not match the specification covered by its approval to ECE Regul…
On eligible units, spokes of the front wheel may contain casting flaws that affect the strength of the front wheel. Continued use of a front wheel containing casting flaws may pot…
In the automatic transmission a small metal tang on the 'brake No 4 tube' may snap off. This piece could stop the engagement of the locking pawl for the P position.
The engine hood safety lock bracket profile may not be formed to specification. As a result, the safety lock may not function correctly. In the worst case, if the vehicle is drive…
Under severe conditions the transmission may overheat. If it overheats lubrication may be inadequate and a gear could fracture.
One of the steel airlines under the cab floor may rub through with contact on the intercooler hose and clamp. If the airline leaks the system will be drained and the spring brakes…
Clearance between the engine hood and the cowl louvre may allow water to enter the engine compartment under certain conditions, ie. heavy rain or frequent car washing. In some cas…
The wheel hub bores in the wheel rim may be too small. As a consequence, the wheel may not make proper contact with the brake disc, although the wheel bolts may have been tightene…
Inspection and/or replacement of the oil cooler to ensure that correct oil cooling unit has been fitted to the motorcycle. This inspection is indispensable, as, if the oil cooler…
There is a possibility that the force which is applied to the tailgate gas strut stopper may, through continued opening of the tailgate, cause fatigue damage to the tailgate gas st…
There is a possibility that the force which is applied to the tailgate gas strut stopper may, through continued opening of the tailgate, cause fatigue damage to the tailgate gas st…
The modification is designed to eliminate any risk of a short circuit in the electrical system in the case where the battery negative cable has rubbed on the air conditioning pipin…
The power steering oil pump may fail to function properly, resulting in an increase in effort required to steer the vehicles, under some use conditions internal parts of the pump m…
The defect relates to the seat belt retractors. It has been found that these retractors do not satisfactorily operate as either an ELR or ALALR. Retractors can be identified by the…
The possibility exists for the plastic casing of the cruise control actuator cable to break, which then may cause the cable to bind and prevent the throttle linkage/valve from retu…
The possibility exists for either of the front indicator lamps to malfunction at times.
There is a possibility that the left hand brake tube may contact the shock absorber while driving and the brake pipe could be damaged.
The electric power supply cable to the starter motor can come into contact with an oil cooler pipe (which could, in time, cause degradation of the insulation on the starter cable).
The tail lamp bulb could become loose in its socket and thus render tail lamp and brake lights inoperative.
The jacks in question did not have a mandatory safety label affixed to the body of the jack. The jacks also do not comply with the overload and durability sections of the vehicle j…