Every safety recall published by the Australian government, searchable and filterable.
Baffle plate and upper tank welded incorrectly and due to internal pressure changes, the tank may crack around spot welding resulting in fuel leakage.
The conversion of the driver's seat has allowed excessive stress to be applied to part of the frame of the seat base which may result in seat frame cracks.
Faulty clamp bolt nuts which may result in possible cracks in nut for M22 U-bolts.
The child restraint anchor fittings may have been incorrectly installed.
Tie rod end bearing manufactured with possible below specification hardness characteristic.
Tread separation whilst in use.
In some conditions, power steering hydraulic by-pass relief system may not function correctly.
Faulty manufactured cab tilt cylinder bracket. The weld on the outside is missing which can cause the bracket to break.
May have a condition wherein the crankshaft pulley bolt may come loose which could dislodge the pulley causing the engine to stop.
Improperly welded cab door screens have potential to allow large debris to enter through door.
Built with a rear shock absorber that could break, causing the rear fo the vehicle to drag on the ground possibly resulting in an accident.
Possible failure of front seat belt buckles in the event of a head on collision.
Rubber boots on lower lateral arm ball joint damaged during assembly.
Potential for failure of a front suspension member.
Possible breakage of the timing belt tensioner spring.
CR - Spacer is too long at the lower attachment. CT - The bolt at the attachment to the cabfloor have too few threads.
Possibility that some vehicles may have a condition wherein the srs control unit may be affected by electrical noise that occurs while starting the engine which in the worst case c…
The Ace air conditioning and power steering fitted to this model applies additional loading to the idler pulley. Failure of pulley will cause drive belt damage which will result i…
High energy inputs into the clutch and flywheel system may lead to structural failure of the flywheel assembly resulting in loss of drive and in extreme conditions the flywheel cou…
Leaking interlock valve drains the park brake circuit and applies the park brake resulting in unintentional application of park brakes.
The Airbag Control Module May Corrode Internally, As A Result Of Water Intrusion Leading To Illumination Of The Airbag Warning Light And Possible Inadvertent Deployment Of The Air…
The Generic Electronic Module (gem) May Exhibit A Loss Of Some Accessory Functions Including Front Windshield Wiper Operation. The Loss Of Front Wiper Function During Inclement W…
The Roll-over Protection System Has Insufficient Weld Penetration. Structural Failure Could Result In Serious Injury Or Death In A Machine Rollover.
If There Is A Poor Electrical Connection Between The Tow Vehicle And The Trailer This May Result In An Interrupted Power Supply To The Brake Unit On The Trailer.
Poor Rustproofing May Have Been Applied To The Front Suspension Coil Springs Which May Lead To Rusting Of The Springs Resulting In Possibility Of Breakage Of This Component.