Every safety recall published by the Australian government, searchable and filterable.
The Boom Speed May Be Too High To Meet Some Local Requirements.
Excessive Paint Thickness On Certain Rear Suspension Components May Result In A Condition Where The Lower Trailing Link-to-axle Bolts May Loosen. This Condition Typically Produces…
Due To A Manufacturing Process Problem A Certain Number Of Pilot Valve Assemblies May Have Been Installed That Contain A Defective Pin. Failure Of This Component Could Cause The D…
A Defect May Exist Whereby The Brake Pad Material May Separate From The Backing Plate; And The Side Stand Switch Fixing Screws May Loosen And Fall Out Due To Engine Heat And Vibra…
A Defect May Exist Whereby The Brake Pad Material May Separate From The Backing Plate; And The Side Stand Switch Fixing Screws May Loosen And Fall Out Due To Engine Heat And Vibra…
The Hydrax supply and return oil lines support bracket clips may fail.
THE BRAKE PEDAL PIVOT PIN MAY NOT BE CRIMPED AT ONE END. CONFIRMATION OF THE CORRECT INSTALLATION OF THE BRAKE PEDAL SHOULD BE PERFORMED.
The Interface Between The Seat Belt And The Soft Top Cover May Not Allow The Seat Belt To Retract.
The Parking Brake Lever Cable Is Too Long Which May Cause The Parking Brake Mechanism To Self Release And Inadvertently Cause An Accident.
Potential For Loss Of Oil Pressure Causing Engine Seizure Which Could Lead To A Loss Of Vehicle Control.
Cracks Or Other Defects Could Exist In The Rear Axles Which Could Lead To Possible Failure.
A Warning Label Was Not Fitted To The Vehicle. The Label Specifies The Correct Type Of Brake Fluid To Use For The Braking System.
The Wheel Retaining Bolts May Not Be Compatible With The Wheel And The Wheel, As A Consequence, May Loosen And Could Come Off.
Some Vehicles Within This Range Were Built With A Fuel Tank Vent System And A Bank Angle Switch That Could Malfunction. Either Of These Conditions Could Cause The Engine To Stall…
Failure Of The Fixing Stud In The Front Axles Can Occur And If Not Attended To The Second Stud Could Fail Leading To Loss Of Directional Control Of The Vehicle.
Starter Cable Interference Which May Result In Electrical Arc And /or Short Circuit.
The Existing Label Containing Tyre Information Located On The B Pillar Contains Incorrect Information.
Due To Incorrectly Machined Clutch Hub Nut, Positioning Tabs Of One Or Both Of The Springs In The Clutch Assembly May Break And Cause The Rider To Lose Control Of The Motorcycle.
Failure Of The Power Steering Pump Pulley May Occur At Low Kilometres As A Result Of Fatigue Cracks. In The Event Of Failure The Serpentine Drive Belt Will Be Subject To Damage R…
The Sealing Plugs In The Cylinder Head Can Work Loose Allowing Coolant To Escape; And The Circlip That Secures The Oil Thermostat Can Work Loose Resulting In An Oil Leak Which Cou…
Possibility That A Front Seat Belt May Not Fully Engage.
Moisture may cause corrosion in driver's side airbag mechanism resulting in airbag deploying unintentionally.
Manufactured With Handlebars That Could Break.
Steering Knuckles May Have Been Manufactured In A Specific Batch Where The Casting Operation May Have Caused Casting Defects To Occur Which May Potentially Compromise The Durabilit…
The Integrity Of A Weld Used In The Rear Semi-trailing Arm Manufacturing Process May Not Have Been In Accordance With Holden Specifications And Subsequently The Durability May Be C…