Every safety recall published by the Australian government, searchable and filterable.
Due to water entering into the ABS hydraulic block computer connector the ABS warning light will come on, disarming the ABS system.
When power is lost to the vehicles indicators the dashboard indicator tell tale still shows that external lamps are working correctly.
The pressure switch that senses the door open function and applies the park brake may not function correctly.
The reinforcing ring within the front lower seatbelt buckles may not have been securely crimped into the seatbelt tensioner cable.
A possibility exists that the fuel tank check valve may have been improperly installed and may become dislodged from its location. In the event that the check valve is dislodged an…
There is a possibility that moisture contained in exhaust gas after cold start may hit the heated ceramic element of the oxygen sensor causing it to fail.
Possibility of torque relaxation on the bolt used to attach the damper to the upper suspension arm.
Has an incorrect fitment of the headlight lens.
The fuel tank steps may bend and develop fatigue cracks due to excessive overhang. This could result in an individual slipping and falling, possibly causing personal injury.
Brake Failure Warning Light marking does not comply with requirements of ADR 35/01.
Possible oil leakage from the alternator lead connector, which could lead to oil deposited onto the rear tyre creating the potential for loss of traction.
The hardness of some Navara D22 Steering Idler Arms might be out of specification. Excessive input from the road surface (for example when the vehicle climbs over a curb) may resu…
The side airbags may not deploy in a side impact as designed. This could result in increased risk to occupants.
The tube that supplies vacuum to the brake booster may crack and cause a loss of braking assistance. This could produce an unsafe condition due to an increase in brake pedal effor…
The rear mudguards (mudflaps) do not fully comply with the requirements of clause 15.2.2 of ADR 42/03. The mudflaps provide insufficient coverage.
At highway speed after extended use the mounting bracket for the rear number plate may fatigue and fall off.
Bendix hand brake control valve may have faulty internal casting that restricts air flow.
The Parking Pawl mechanism may fail to restrain the vehicle when parked if the handbrake is not correctly applied. If an affected vehicle is restrained in a parking situation by t…
Due to static electricity discharge, the side airbags may inadvertently deploy when a person is alighting either the passenger or drivers side front seats.
Rear Luggage Rack Kits may have been released into the market with incorrect specification locknuts, which could cause the luggage racks to become loose and possibly cause vehicle…
Floor mounting leg of the coach seats may partially tear in a crash.
Faulty software within the Electronic Control Unit for the transmission may activate reverse gear when travelling below 3km/h.
There is a possibility that the Side Support Stand may have a safety defect that could cause them to bend or break without notice, thereby allowing the motorcycle to fall and pote…
Dana Australia has advised that the inner CV joints of the IRS half shafts fitted to certain BA 16 sedan models may have been assembled without a retaining circlip. This may allow…
A brake lamp switch malfunction may develop rendering the brake lamps inoperative.