Every safety recall published by the Australian government, searchable and filterable.
There is the potential for a foul to occur between a brake pipe and an engine mounted hose clip, which could eventually result in failure of the brake pipe. This failure could resu…
Either the pivot bolt for the sidestand leg or the mounting bracket bolts could break (possibly without notice) and could cause the motorcycle to fall.
Some air conditioners may not comply with the requirements of the consumer product safety standard for electrical installation. The power supply fitted under the chassis floor may…
Due to improper moulding of the resin body of the crankshaft position sensor installed on the engine block, engine oil may penetrate the seal and enter the sensor wiring connector.…
The transverse beam end castings on certain Holland AD rear suspensions may not have been manufactured to the correct material specification and could fracture under normal loads.…
The lower rubber mounts may come loose from the rear shock absorbers. If this occurs , wheel guidance would be lost and, depending on the driving situation, it may no longer be pos…
Has the potential to leak brake fluid.
Under extremely high dynamic loading there is a possibility that a fracture could occur at the crimp crease of the crimp connections on the front lower transverse control arms. Sho…
Inspection of handbrake lever required.
The wiper motor armature could sieze and break, thereby rendering the wiper motor inoperative and compromise the driver's forward vision in wet conditions.
One or more of the special fasteners securing the hub to the steering wheel may be too short to provide the required engagement on the pin, which in turn could cause the steering w…
Poor contact between ignition switch contacts may lead to arcing, causing burning of the contacts and increased electrical resistance. Heat generated due to the increased resistanc…
There is a concerned relating to the brake pads fitted on a limited range of axles equipped with maxi brakes. This may cause overheating due to the dragging brake pads.
There is a potenial safety concern that relates to the knuckle arm fixing bolts. The longer of the two bolts has been incorrectly manufactured and has not been heat treated inline…
There is a possibility that the steering intermediate shaft may become loose or develop a crack. In the worst case, if the vehicle continues to be operated under these conditions,…
There is an issue that may result in excessive wear of the rear wheel bearings that will lead to noise occuring from the rear axle. If this is not rectified, the bearings could ult…
Connection between shaft and universal joint on steering propshaft may work loose.
The stop of the brake pedal collapse system may be missing which in extreme circumstances could diminish braking efficiency and affect safety.
Due to insufficient strength of the rear axle shaft flange, a crack may develop at the neck of the flange if the vehicle is operated in certain driving conditions, such as repeated…
The outer tie rod end joints, on the steering gear, may fracture.
The Fuel Filler Tube may rust at the tube mounting bracket as a result of the plating and painting (powder coating) which may have been insufficiently applied. If a pinhole is form…
It has been determined that the fuel line connecting to the engine is sensitive to extreme temperatures, that may occur in the area where the turbo/exhaust manifold is located, pot…
The transverse beam end castings on certain Holland Neway AD rear suspensions may not have been manufactured to the correct material specification and could fracture under normal l…
If the hydralic brake pipe fouls on the shock absorber the concern is that it could eventually wear through allowing the hydraulic fluid to escape, which would lead to the loss of…
An incorrect plastic clip has been fitted to the plenum panel on a limited number of early build VZ/WL vehicles. This incorrect clip is a circular type, and if fitted, will contact…