Every safety recall published by the Australian government, searchable and filterable.
During manufacture, bolts used to assemble steer and drive axle ABS combination valves, and a traction control valve inlet fitting, were torqued below specification. The torque val…
The 24 to 12 volt voltage reducer can generate excessive heat if subject to moisture ingress which, in turn, could lead to the component burning and subsequently damaging surroundi…
Under certain conditions, the Bendix EC-17 ABS ECU may misinterpret certain signals from the wheel ends, which can result in the temporary loss of braking capability in one or more…
Fuel used for finished product inspection during production of the eligible units may have been contaminated. This could cause swelling damage to the diaphragm in the carburetor a…
Fuel used for finished product inspection during production of the eligible units may have been contaminated. This could cause swelling damage to the diaphragm in the carburetor a…
Fuel used for finished product inspection during production of the eligible units may have been contaminated. This could cause swelling damage to the diaphragm in the carburetor a…
The presence of air has been detected in the hydraulic lines of the brake system, leading to a gradual reduction in efficiency and a spongy feel to the brake pedal.
The level sensor float inside the brake reservoir can become dislodged and jammed, rendering the low fluid level warning light inoperative.
With steel flex brake lines with a PA internal hose, the long suspension travel distrances can cause the internal hose to tear. Brake fluid is then able to escape through the stee…
The 24/14 Front spring brake chamber on the rear axles may leak while the vehicle is in motion.
The thermal fuses fitted in the engine bay may not have been installed by the bus or coach bodybuilders. The thermal fuses form part of the fire hazard warning equipment.
The vacuum control hose between the Exhaust Gas Recirculation valve and the Electronic Vacuum Regulator may become chafed or heat affected due to close proximity to a heat shield.…
May experience a loss of power assist to the brakes, due to a collapsed brake booster vacuum hose. Loss of brake booster vacuum without warning may result in increased pedal effor…
A crack can occur in the protective sheath of the flexible front brake hoses.
There is a possibility that the front brake hose can be twisted due to the location of the front brake hose mounting bracket and as a result the front brake hose may be put under e…
The rear disc brake may crack.
The power steering rack hydraulic unions may not have been tightened to the correct torque during assembly. This could lead to a loss of power steering fluid and possible loss of…
The possibility exists for the Fog Lamp bulb sockets to come adrift from their mounting, allowing the globes to make contact with the inner portion of the front bumper bar.
The fuel pump module mounting flange may leak if the vehicle is involved in a rollover collision.
The plastic fuel pipes between the injection pump and the hand pump is chafing against their brackets. This can cause fuel leaks.
The front brake hose locating bracket may fail allowing the hose to possibly contact the front wheel.
The rear brake line could fracture internally, which may allow leakage of brake fluid which could cause malfunction of rear brake system possibly, without warning, which could lead…
The rear brake line could fracture internally, which may allow leakage of brake fluid which could cause malfunction of rear brake system possibly, without warning, which could lead…
Possible cracking of the brake drums from the inside out.
There is a risk that the left-hand front anti-roll bar linkage may come into contact with the brake pipe.