12 safety recalls published for the Mitsubishi Outlander (2006–2023).
Due to a manufacturing defect, the steering wheel touch sensors may be defective. As a result, the vehicle may not accurately detect the driver's hands on the steering wheel and th…
Due to a software issue with the In-Vehicle Infotainment (IVI) unit, the rear-view camera display may not display the rear camera image as intended.
The structure of the front deck allows water intrusion onto the windshield wiper motor. Water accumulated around the wiper motor breather hole is drawn into the motor as it cools d…
Water may enter between the hood and windshield and cause the front wiper link ball joint to corrode, possibly resulting in the wiper link separating and the wipers becoming inoper…
Due to improper engine software, EV software and spark plug specification, the petrol engine may shut down unexpectedly. This will limit the vehicle to EV drive mode only, with no…
An inappropriate manufacturing process of an electrical part on a manufacturing line may cause the voltage inside the ETACS ECU to be unstable.
Due to a running vehicle wiring harness design change at Mitsubishi, the electric trailer brake accessory harness that Mitsubishi had been selling is not suitable for 16MY Outlande…
Due to poor conductivity caused by the presence of an insulating material, the brake lamp switch may not operate correctly, and in some vehicles it may also prevent the gear shift…
The potential defects or combination of defects are as follows:(1) The Electronic Power Steering computer may fail, causing the EPS warning lamp to illuminate and in the worst cas…
The potential defects or combination of defects are as follows:(1) The Electronic Power Steering computer may fail, causing the EPS warning lamp to illuminate and in the worst cas…
The potential defects or combination of defects are as follows:(1) The Electronic Power Steering computer may fail, causing the EPS warning lamp to illuminate and in the worst cas…
On affected vehicles, the brake light switch may have been contaminated with silicon grease during installation which could result in a high resistance at the contact point and pre…