Every safety recall published by the Australian government, searchable and filterable.
An inappropriate manufacturing process of an electrical part on a manufacturing line may cause the voltage inside the ETACS ECU to be unstable.
The turn signal and lighting switch connector terminals may become worn during switch operation due to insufficient rigidity. This may result in an accumulation of oxidised dust on…
The rear right hand side parking brake cable may interfere with fuel tank and may result in damage to the protective coating of the fuel tank.
It is a mandatory requirement that a motorcycle must have each mechanical component accurately stamped and displayed for identification purposes according to regulation for ADR com…
Moisture may enter the air bag module because of a misalignment of the air conditioning system drain tube.
Drivers may inadvertently fail to engage the “PARK” position before exiting the vehicle.If the engine is left running, the “PARK” position is not engaged and the “PARK BRAKE” is no…
Low battery at engine startup combined with parking while the wheels are turned, can cause a miscalculation in the steering ratio, which may lead to a lack of steering responsivene…
The cap nut that retains the inter-axle driveshaft yoke to the rear axle input shaft may be subject to premature loosening.
The screws of the rear toe-in adjustment rods may loosen.
The main cabin power supply cable connections may not have been tensioned correctly during production.
Quality deviations in the production process of the connecting rod may result in early failure and fracturing of the conrod under certain load conditions.This issue is identified t…
Quality deviations in the production process of the connecting rod may result in early failure and fracturing of the conrod under certain load conditions.This issue is identified t…
The ignition switch may become damaged internally due to engine induced vibration.
An electrical wiring harness connector may not have been completely secured to the steering column during vehicle manufacture.
Vehicles were manufactured with front axles that do not meet overall width requirements set out by Australian design Rules.
There may be an oil leak at the plug connection, and software for the semi active shock requires updating.
On vehicles with a 2.0l petrol engine, of a limited production period, the drive cam for the vacuum pump can break. As a result there is no vacuum assistance when applying the vehi…
Magyar Suzuki Corporation has identified a possibility that during production the front seat back may have been assembled with incorrect stitch seam spacing, outside of the manufac…
Magyar Suzuki Corporation has identified a possibility that during production the front seat back may have been assembled with incorrect stitch seam spacing, outside of the manufac…
The roof lifting system could drop up to 450mm during opening or closing operations.
There is a potential for interference of the wiring under the dashboard within the steering column, which may cause the wiring to wear out over time.
Some brake actuators may have been assembled with a pump containing an O-ring that is damaged and as a result may not operate as intended.
The specified limits of the roll back function of the sunroof may be exceeded when closing using the remote key.
The automatic transmission fluid cooler hose may have been improperly cured during the manufacturing process, thereby increasing the possibility of transmission fluid leaking from…
A circlip on the bearing bracket of the brake pedal may become detached from its locking position. As a result, the bearing pin can move out of one of the two bearings, impairing b…