Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing error within the fuel injection pump it is possible that engine oil and fuel could become mixed and find its way into the engine.Should this occur an unexpec…
The above vehicles may experience poor performance, fuel smell, engine noise, a fuel leak onto the rear of the engine, a fuel leak onto the ground or a fire, as a result of the fro…
Due to a manufacturing error within the fuel injection pump it is possible that engine oil and fuel could become mixed and find its way into the engine.Should this occur an unexpec…
Discovery 3 vehicles LA367110-LA440000 and Range Rover Sport LS929086-LS117000.Oil may migrate from the engine driven vacuum pump and collect in the brake booster.This may cause a…
The power steering unit on these vehicles may not always provide the assistance the rider is expecting, leading them to apply more forces to the handlebars.At this increased level…
The transmission oil cooler lines below the transmission may crack under certain circumstances. Should this occur, transmission oil may leak on to the road and pose a hazard to ot…
Due to the design of the bracket, the LED controller may come in contact with the oil filter. Over time, this contact can lead to a hole in the oil filter and a possible oil leak.…
The affected vehicles windshield may not be chemically bonded to the Polyurethane (PU) adhesive. Where the windshield is not chemically bonded, water ingress may occur and there ma…
A concern has been identified with corrosion to brake pipes at the junction between the twin under floor pipes and the rear cross member pipes fitted to 2003 and certain 2004 MJ XJ…
The foot peg pivot pin may bend due to insufficient hardness of the metal.
The side indicator lights on the front fenders do not comply with current Australian Design Rules for lateral visibility.
When examining the clamping joint on the track rod and drag link, defects in tolerances and corrosion have been found.
The previous software upgrade for the engine control unit may not fully overcome the possibility of piston damage occurring as a result of a less than ideal combustion process. If…
A concern has been detected relating to the engine air intake duct which may become disconnected due to thermal loading combined with normal engine vibration. If this happens, the…
Volvo Car Corporation have identified that the engine cooling fan may permanently stop working due to a software error in the Fan Control Module (FCM). If the fan stops it may caus…
The engine air intake duct may become disconnected due to thermal loading combined with normal engine vibration. If this happens, the engine will exhibit rough idling and in a wors…
There have been instances where the screw for the brake pedal's mounting has not been fully engaged in its flange nut.
The engine air intake duct may become disconnected due to thermal loading combined with normal engine vibration. If this happens, the engine will exhibit rough idling and in a wors…
In certain high speed, high engine RPM situations foaming can develop in the front brake master cylinder reservoir.
The Ohlins RH front fork leg may feature a flaw, which could result in safety problems, especially in case of misuse of the motorcycle.
The brake booster check valve may develop a vacuum leak.
The brake booster check valve may develop a vacuum leak.
The acorn stud at the brake reaction link may fall out during use. If this occurs the front brake and fender assembly would no longer be adequately retained. This condition could l…
The turbo heat shield mounting could break and cause the steering shaft to jam; this may require extra effort to turn the vehicle
In some instances the lubrication to the supply pump drive bearing may be insufficient.