Every safety recall published by the Australian government, searchable and filterable.
The turn signal mounting stalk can break easily, causing the turn signal light to fail to clearly indicate the operator's intention to turn.
Certain slack adjusters on SISU may have been machined with a counter-bore in the slacker adjuster housing that reduced the material thickness between the worm wheel opening and th…
The vehicles may have been produced with the turbo charger oil supply pipe deformed due to misalignment during the assembly process. If the pipe is deformed, vibration experienced…
Insufficient holding of the vehicle (only one wheel locked).
The compnay has determined that windshields on these model motorcycles, built during the above date range and fitted with a rubber-mounted nut (part numbr M025.1AV), may become dis…
Suspension arm nuts need re-tightening.
The fuel filler flange on the fuel tank is incorrectly formed, leaving a section tht is unsealed. This may allow the fuel to leak if the fuel reaches the unsealed section in certai…
A potential for uneven braking (side to side) due to a software error within the EBS control unit.
Under extreme exposure levels to engine oil, contained in the combustion blow-by gas, the material compound of the Intercooler Outlet Pipe Insulator may swell and, as a result, dis…
On affected vehicles, the front door glass run channel (left and/or right) may have been incorrectly installed and as a result, there is the potential that when the front door glas…
During the manufacturing process, damage may have occurred to a joint in the handbrake lever assembly mechanism. Continued use may cause sufficient wear for the joint to detach and…
The rear axle hub nuts (RWD models) or front and rear axle hub nuts (AWD models) on the vehicles may loosen and allow the half shaft to disengage from the wheel hub. This could cau…
The eligible units have been supplied with a mounting bracket and side reflectors that do not comply with Australian Design Rules.
Due to a faulty metallurgical process the hose fitting on the left rear park brake cable may detach and cancel the holding effect of the handbrake. This can also occur after the ve…
There is a possibility that the rear view mirror may crack while riding. In the worst case, the mirror may not have enough strength against vibration in the long term, which may ca…
There is the potential in the event a vehicle with a full tank of fuel is involved in a severe collision, that the LHR fuel tank retaining strap bracket may fail allowing the fuel…
Condensation from the air conditioning evaporator mounted in the HeVAC unit can come into contact with the control circuitry for the additional electric booster heater; and a short…
Condensation from the air conditioning evaporator mounted in the HeVAC unit can come into contact with the control circuitry for the additional electric booster heater; and a short…
Due to an incomplete soldering process during manufacture, certain electrical connections on the circuit boards of the ABC body acceleration sensors may trigger random sprung mass…
Due to irregularities in the axle hardening process it is possible micro-fissures may develop in the axle which could lead to eventual failure and loss of drive power.
Vans may have been incorrectly fitted with spring leaves on the rear axle which are 1mm too thick, which could cause the spring to break unexpectedly. Should this occur, and depen…
It is possible that standard bolts rather than metric bolts may have been used in production to attach the brake caliper to the anchor plate at each wheel assembly. Incorrect bolt…
There is the potential for the Accumulator fitted to the Hydraulic Brake Booster (HBB) to lose pressure.
Certain 2001-2003 MY Subaru Impreza hatches may have been manufactured with tailgate struts (also known as tailgate stays) that were inadequately tightened during production. The l…
A safety strap will be fitted to each of the awning arms to ensure that should the gear in the electric motor break the awning is secured to the van.