Every safety recall published by the Australian government, searchable and filterable.
There is the potential for a foul to occur between a brake pipe and an engine mounted hose clip, which could eventually result in failure of the brake pipe. This failure could resu…
There is the potential for a foul to occur between a brake pipe and an engine mounted hose clip, which could eventually result in failure of the brake pipe. This failure could resu…
There is a possibility that in isolated cases a gradual loss of gas can occur in the gas generator for the curtain airbags, thereby causing the airbag not to inflate when required.
A potential problem with the reara brake caliper carrier positioning stud (stop bolt) which could result in brake caliper carrier movement, thereby possibly causing damage to the r…
The manufacturer has advised of a possible software fault in the SRS control unit which, if present, could prevent the generation of a crash signal in the event of a rear end colli…
Either the pivot bolt for the sidestand leg or the mounting bracket bolts could break (possibly without notice) and could cause the motorcycle to fall.
Due to an oversight that may have occurred in production some vans were not fitted with rear mudflaps in accordance to the certification specification.
Due to an oversight that may have occurred in production some vans were not fitted with rear mudflaps in accordance to the certification specification.
After high frequency use of the ignition switch there is a potential for failure of the switch contacts. Should the contacts fail, it could lead to the starter motor continuing to…
Water leaking into the ABS switch in the cockpit can lead to the malfunction of the switch and in some cases to a failure of the speed indicator.
A condition can occur where water may enter the Anti-Lock Brake System (ABS) wiring connector via the earth lead.
Some air conditioners may not comply with the requirements of the consumer product safety standard for electrical installation. The power supply fitted under the chassis floor may…
There have been instances of leakage from the return fuel line on ethanol-driven buses with a DSI9E engine.
In the subject vehicles equipped with N04C-TF engine (turbocharger with waste gate system), when repeatedly accelerating at high speed, excessive vibration may be generated within…
Due to improper moulding of the resin body of the crankshaft position sensor installed on the engine block, engine oil may penetrate the seal and enter the sensor wiring connector.…
The splines on the engine pulley and/or pulley shaft may be worn due to the use of the wrong assembly lubricant during assembly. This can result in the engine pulley mounting nut n…
A concern has been detected related to incorrect assembly and manufacture of the rear axle assembly of the vehicles. This may result in excessive wear of the rear wheel bearings th…
Some of the steel used in the manufacture of the tanks has inconsistent levels of tensile strenth. Some of the tensile strenth is below the tensile strength required by AS/NZS 1594…
The close proximity mirror has mistakenly been manufactured from incorrect raw materials. The materials in the existing mirrors are more fragile than they should be and risk cracki…
The transverse beam end castings on certain Holland AD rear suspensions may not have been manufactured to the correct material specification and could fracture under normal loads.…
The lower rubber mounts may come loose from the rear shock absorbers. If this occurs , wheel guidance would be lost and, depending on the driving situation, it may no longer be pos…
Has the potential to leak brake fluid.
Under extremely high dynamic loading there is a possibility that a fracture could occur at the crimp crease of the crimp connections on the front lower transverse control arms. Sho…
Inspection of handbrake lever required.
The wiper motor armature could sieze and break, thereby rendering the wiper motor inoperative and compromise the driver's forward vision in wet conditions.