Every safety recall published by the Australian government, searchable and filterable.
The triggering of the front airbags may not meet legal requirements.
The bolt of the Steering Damper is not tightened sufficiently by the assembly operation error. There is a possibility that the bolt loosens and the Steering Damper comes detached f…
It is possible for the front left brake hose and/or the front left ABS whell speed sensor lead and/or the front left brake pad wear sensor lead to chafe against the clip on the lef…
The transverse beam end castings on certain Holland Neway AD rear suspensions may not have been manufactured to the correct material specification and could fracture under normal l…
The compliance plate currently fitted to vehicles affected shows an incorrect 'Gross Vehicle Mass' (GVM) value.
Accelerator pedals require replacement.
A possibility exists that if the front seat belts are extended quickly with strong force, the internal components of the Emergency Locking Retractor (ELR) may jam and the seat belt…
There is a possibility that the seat belts fitted to the passenger seats may become frayed and damaged on the unprotected metal frame of the seat backing.
The left hand lower front axle shock absorber mount can, over an extended period, experience fatigue failure. If this happens it could potentially foul the steering linkage impedin…
If the air bag is inflated in very cold conditions, there is a possibility that the horn bolt could fracture, causing the horn switch components to be scattered.
If the hydralic brake pipe fouls on the shock absorber the concern is that it could eventually wear through allowing the hydraulic fluid to escape, which would lead to the loss of…
In the airbag system of the subject vehicles, due to Incorrect assembly process of the airbag inflator, which is used in the curtain sheild airbag and the knee airbag systems, some…
Excessive play on rear LH and RH seatbelt stalk fastener. This does not have any impact on the efficiency of the seatbelt. In exceptional cases however it may eventually cause loos…
An incorrect plastic clip has been fitted to the plenum panel on a limited number of early build VZ/WL vehicles. This incorrect clip is a circular type, and if fitted, will contact…
These vehicles have been fitted with an incorrect tyre placard label.
It has been found that there is a risk the Gear Lever may break if subject to high handling force.
A possible leak at the join of the flex pipe to the steel pipe in the rear brake pipes.
During the assembly process, small strands of loop wire were fitted to the fuse panel to test the electrical circuits at buils completion. On some vehicles it has been found that t…
The tyre side wall may exhibit signs of abnormal appearance. This may indicate partial seperation of certain components of the sidewall and could possibly lead to rapid pressure lo…
The affected tyres may not have adequate rubber coverage of the belt edge due to low tread gauge in the sholder slot area of the tyres. It may eventually cause cracking at the base…
The handlebar clamp bolts may have been tightened to the incorrect torque.
There is a possibility of an improper connection between the valve and the piston in the brake intensifier and in the worst case the brake may not fully release after application.
If the electrical earth wire that is fitted underneath either front seat becomes detached, an electrostatic charge can cause the side airbag to deploy when the car is stationary an…
The engine management software can, in rare cases, cause imperfect management of the engine fuel supply which could lead to engine damage.
R0511: In the enent of certain frontal collisions, the Outer Rear Seat Belt webbing can contact the Rear Seat Back Hinge, and there is a possibility it can be cut by the sharp edge…