Every safety recall published by the Australian government, searchable and filterable.
The wiring associated with the power front seat may cause overheating of the circuit breaker in the interior fuse box.
Certain Terracan vehicles were produced with front brake disc rotors that may have insufficient material thickness between the flange and friction surface. Under extreme condition…
The brake pipe cradle can rub the adjacent brake pipe causing a loss of fluid.
There have been some instances of the 8mm brake pipe detaching at certain locations on this vehicles resulting in a loss of air pressure in the breaking system.
The mudguard does not comply with the Australian Design Rules and the use of the vehicle may potentially cause damage by the flicking of stones from the rear of the tyre.
A rear view mirror is improperly located and it is not possible to adjust the mirrors towards the rearward field of vision.
The throttle cables may contact the tunnel portion of the fuel tank. Should this occur the cables could wear through the fuel tank causing a fuel leak.
The fuel pump retaining ring may have been improperly installed. This may cause some leaking of fuel from the fuel tank in certain circumstances.
There is a possibility that the pinch bolt is not correctly tensioned on the upper end of the steering column and/or the splined column shaft is not fully inserted into the female…
Tightening torgue on the propeller shafts could result in vibration if not rectified couls result in a propeller shaft becoming detached.
A possible defect exists in an engine camshaft sensor component. If the sensor does malfunction, the sensor may melt generating possible odour and visible smoke and may subsequentl…
There is a possiblity of the carpet mat slipping towards the cpntrol pedals, consequently interfering with the operation of the throttle pedal. In the worst case, the carpet mat co…
The B+ terminal may be in conflict with the starter motor solenoid in the cars concerned.
The transmission may not fully engage Park when it is selected.
The transmission may not fully engage Park when it is selected.
Rare occurence of the inadvertent operation of the starter motor.
The swingarm may malfunction.
A notching effect may be present in the left or right side wiper arm which could in turn weaken it. A possible consequence is that the arm may fracture when placed under high loads…
Moisture may penetrate the steering shaft in your Mercedes-Benz truck.
The Stationary Noise Label is incorrect.
Due to insufficient strength the steering knuckle arm fitted to the truck may crack if frequent stationary steering operation is applied.
Some vehicles are fitted with an incorrect scissor style jack.
The connector locking tab on the fuel hose that connects to the fuel inlet pipe on the engine may not be fully based and, as a result, the hose may become dislodged. In the worst c…
A possibility of a thermal malfunction on water seperator bowl with heater. There is a risk of overheating due to low fuel level in combination with a faulty thermostat in the wate…
In the subject vehicles, the headlamp dimmer switch contact points may overheat due to high internal electrical resistance caused by residue build up on the surface of the contact…