Every safety recall published by the Australian government, searchable and filterable.
The driver's seat belt pre-tensioner may not operate when required.
The left front brake caliper may have been cast from an incorrect material.
In the event of a failure of the main battery the electronic ignition lock will not be supplied with power by the backup battery. If the engine stops during use the electric parkin…
The paint coating applied during the supplier's manufacturing process of the Back Door Gas Stay does not comply with the design requirement for anti-corrosion. In extremely rare ci…
The vehicle is affected by non-conforming front brake discs whose mechanical characteristics are non-compliant. This may cause a risk of reduction in the braking efficiency and cou…
On some units, the circlips securing the passenger footrest pivot pins may be brittle due to a manufacturing defect.
In some vehicles, the brake booster piping connector may be non-compliant with relevant standards.
There is a potential deviation in the buckle heat treatment process. The seat belt anchorage links may not comply with safety standards.
The transmission cooler hose was not manufactured to the correct specifications. During prolonged use there is a risk of fluid leakage, which could result in mechanical failure of…
The lower nut and bolt that secures the front suspension strut to the steering knuckle may not have been tightened with sufficient torque. This may cause the nut to loosen and fall…
The accelerator pedal could become entrapped by the floor mat in any operating position.
There is a possibility that during the manufacturing process of the vehicle the adhesive used to secure the steering pinion gear to the steering gear assembly had insufficient stre…
The fitted flange head bolts may loosen in use.
Due to the possibility of corrosion on internal components, the restraint system control unit may fail. As a result the restraint system components such as the airbags could be dea…
The air intake ducts may develop cracks.
On the affected vehicles, the power steering pipes may crack over time, causing power steering fluid leaks and results in a lack of responsiveness in steering.
On affected vehicles, the travel of the parking brake lever might have been incorrectly set. This situation could lead to the parking brake being ineffective unless the customer pu…
The steering damper bracket mounting bolts could break due to over tightening during assembly.
The engine can momentarily cut-off and immediately restart while driving. This issue may cause disturbances in some electrical systems such as shut down of the instrument cluster,…
Due to a manufacturing defect, one of the securing nuts on the Rear Brake Hose Flange may not be tightened to the correct specification.
In the event of a high-speed frontal collision, there is a possibility that the seatbelt webbing could contact a portion of the metal seat cushion frame, become cut and separate.
The seat belt bolt in the rear compartment section of the motorhome may work itself loose over time.
Improper routing of electrical wires under the fuel tank may cause the leads come in contact with frame edge. In addition, on certain models (JKBEJCA1?A000108 - JKBEJCA1?A015716),…
The regulator/rectifier power module circuit board may have absorbed moisture during storage in highly humid conditions. This may have reduced the strength of the adhesive used to…
Rocker arm bearings in the engine may fail after prolonged exposure to degraded oil.