Every safety recall published by the Australian government, searchable and filterable.
Ignition switch malfunction may result in the engine stalling without warning. This condition may occur due to a high current surge passing through the ignition switch during the…
On FL H-Medium and E-Medium vehicles, in combination with electrical controlled air suspension (SUSPL-EC), the brake reaction time is too slow. This is due to an air flow restrict…
The oil feed pipe for the turbo compressor could crack and leak oil.
The rust preventative oil applied to the brake pedal assembly can leak into the brake lamp switch and contaminate the electrical contacts, which may result in the brake lamps not i…
Due to a problem with the chromating process, the front brake caliper piston may release hydrogen gas into the brake system. This could result in reduced, or lost braking capabilit…
The tie-rods of throttle valves of the motorcycles involved could interfere with the engine air box thereby causing a possible lock of the throttle mechanism.
Relates to the park brake locking mechanism fitted to the N16 Pulsar 5 door hatch. There is a possibility that the park brake may self-release as a consequence of an impact with th…
The steering gear mounting bracket missed a machining process and the bolts that secure the steering gear may have incorrect thread penetration into the gear body, either or both o…
The overhead consoles, which house multiple radios, can in some cases, have insufficient strength and cause the radios to fall on or near the driver.
The Automatic Shift Manual transmission fitted to the vehicles may change to a lower gear unexpectedly. Affected vehicles require the TCU (Transmission Control Unit) recalibrated.
Due to a section of the main harness located on the back of the fuel tank being rubbed by the metal clamp of the fuel pump leads, possible abrasion of the main harness sheath and t…
A potential abrasion condition between the front left hand flexible brake hose and tyre. The front left hand tyre can contact the hose and cause abrasion to the outer lining mater…
Wheel nuts at the lower end of the torque range may come loose on rough roads, thus imposing greater loads on adjacent nuts which may fatigue fracture.
Possibility of water entry into the engine management solenoid valve operating circuit.
The wheel speed sensor for the ABS can be deceived by metallic debris in the area and transmsit an incorrect wheel speed signal.
The throttle cable may have been damaged during manufacture, which could cause the inner cable to rub resulting in individual strands of the cable breaking.
The handbrake applicaton may vary up to two clicks between successive applications; and The adjuster wedge in the back plate may misalign changing the brake shoes required travel.
Under extreme braking conditions the affected ABS modules may lose all brake fluid from front braking circuit.
The side airbag warning light may inadvertently become activated, due to several possible problems associated with wiring connectors fitted on these vehicles.
The plastic fuel lines may not be secured properly and can be damaged.
There have been instances of the steel ball in ports 1 and 2 on the interlock valve coming loose which may lead to the parking brake being applied.
The driver's side knee bolster assembly may have been improperly installed. As a result, the knee bolster could separate from the upper instrument panel and fall onto the driver's…
The backrests could under certain conditions, inadvertently detach from their front mounts. This could cause the passenger to shift his/her position, possibly resulting in persona…
Part Nos. 66693-98 and 66680-98: the rear brake pedal could come in contact with some Screamin Eagle Race Brace supports which could limit the travel of the rear brake pedal thus p…
Abrasion, leading to possible fuel leakage can occur between the fuel line and accessory custom horn cover.