Every safety recall published by the Australian government, searchable and filterable.
Faulty clamp bolt nuts which may result in possible cracks in nut for M22 U-bolts.
The child restraint anchor fittings may have been incorrectly installed.
Tie rod end bearing manufactured with possible below specification hardness characteristic.
Tread separation whilst in use.
In some conditions, power steering hydraulic by-pass relief system may not function correctly.
Faulty manufactured cab tilt cylinder bracket. The weld on the outside is missing which can cause the bracket to break.
May have a condition wherein the crankshaft pulley bolt may come loose which could dislodge the pulley causing the engine to stop.
Improperly welded cab door screens have potential to allow large debris to enter through door.
Built with a rear shock absorber that could break, causing the rear fo the vehicle to drag on the ground possibly resulting in an accident.
Possible failure of front seat belt buckles in the event of a head on collision.
Rubber boots on lower lateral arm ball joint damaged during assembly.
Potential for failure of a front suspension member.
The air start solenoid and back-up relay needs to be reworked to ensure the starting system is properly grounded.
The start relay and back-up relay wiring needs to be reworked to ensure the starting system is properly grounded.
Possible breakage of the timing belt tensioner spring.
CR - Spacer is too long at the lower attachment. CT - The bolt at the attachment to the cabfloor have too few threads.
The engine harness mounting may come into contact with the injector line which can result in fuel leakage under pressure and risk of fire.
Possibility that some vehicles may have a condition wherein the srs control unit may be affected by electrical noise that occurs while starting the engine which in the worst case c…
The Ace air conditioning and power steering fitted to this model applies additional loading to the idler pulley. Failure of pulley will cause drive belt damage which will result i…
High energy inputs into the clutch and flywheel system may lead to structural failure of the flywheel assembly resulting in loss of drive and in extreme conditions the flywheel cou…
Leaking interlock valve drains the park brake circuit and applies the park brake resulting in unintentional application of park brakes.
The Brake Pipe From The Front Distribution Line To The Rear Pressure Regulation Valve May Interfere With The Vehicle Floor. This Condition May Lead To Wear, Perforation Of The Pip…
The Airbag Control Module May Corrode Internally, As A Result Of Water Intrusion Leading To Illumination Of The Airbag Warning Light And Possible Inadvertent Deployment Of The Air…
The Generic Electronic Module (gem) May Exhibit A Loss Of Some Accessory Functions Including Front Windshield Wiper Operation. The Loss Of Front Wiper Function During Inclement W…
Fault In Electronic Circuitry Of The Heater Blower Regulator Which Could Lead To Overheating And Subsequent Melting Of Surrounding Plastic Or Insulation Material Even When The Vehi…