Every safety recall published by the Australian government, searchable and filterable.
The upper control arm retaining bolts may have been damaged during vehicle assembly. This may cause the upper control arm to detach from the steering knuckle while driving, resulti…
Due to a manufacturing defect, the vibration damper may not have been tightened to the correct torque, causing it to potentially become loose and detach from the vehicle. This coul…
Due to a manufacturing defect, spark plugs may have been damaged during assembly. This may lead to unstable idle, hesitation and possible engine stall whilst riding, resulting in a…
Due to a manufacturing defect, oil cooler lines could burst resulting in a sudden loss of oil pressure. This could lead to the engine stalling or an oil leak. An oil leak in the pr…
Due to a manufacturing defect, the front passenger side window may not have been tinted to the specifications required under Australian Design Rule 08/01 – Safety Glazing Material.…
The fixings for the fuse box cables may not have been tightened to the correct torque. This could lead to a sudden loss of motive power, loss of headlights and power assisted steer…
Due to a manufacturing error, incorrect disconnect switches and junction box mounting brackets may have been installed. This could cause the battery cable to break and result in a…
Due to a software issue with the In-Vehicle Infotainment (IVI) unit, the rear-view camera display may not display the rear camera image as intended.
Due to a software issue in the Integrated Charging Control Unit, the auxiliary 12 Volt battery may not charge as intended, resulting in battery drainage and loss of motive power.
Due to a manufacturing issue, the front and rear window glass may have insufficient bonding to the vehicle’s body.
Due to a software issue in the Integrated Charging Control Unit, the auxiliary 12 Volt battery may not charge as intended, resulting in battery drainage and loss of motive power.
Due to a software issue, the Integrated Charging Control Unit (ICCU) may develop an internal fault causing a warning light to illuminate on the instrument cluster and the 12 Volt b…
Due to a software issue, the headlamp high beam setting may not operate as intended. This could result in reduced or poor visibility.
The electrical power steering control unit back-up software may not operate as intended. In the event of a failure of the power steering control unit, this could result in a loss o…
Due to incorrect software being installed in the vehicle, the ‘fail-safe’ mode may not operate when oil pump faults are detected in the dual clutch transmission. If this occurs it…
The base area of the vehicle jack may not meet the minimum size requirements of the Australian Consumer Product Safety Standard. If a non-compliant vehicle jack is used, it could b…
Due to a manufacturing issue, the driveshaft may brake under load. If this occurs, it may lead to a sudden loss of motive power.
Due to a manufacturing defect, the driveshaft may break under load. If this occurs, it may lead to a sudden loss of motive power.
Due to a manufacturing issue, the threaded nut securing the 48 Volt wiring harness under the driver seat may become loose. If this occurs, it could result in higher than normal ele…
Due to a manufacturing defect, the vehicles are missing a hand rail adjacent to the service door as required by Australian Design Rule (ADR) 58/5 – Access to and from omnibuses. Ad…
Due to a manufacturing issue, an incorrectly routed power cable could contact a ground stud of the vehicle and short circuit. This may increase the risk of overheating and a vehicl…
Due to a manufacturing issue, the side curtain airbags may be fitted with a faulty gas generator. As a result, the airbag may not deploy as intended.
Due to a manufacturing defect, the bracket retaining the engine control unit could interfere with the vehicle’s wiring in the event of a collision, causing a short circuit resultin…
This is a re-notification of REC-000585.Due to an improper manufacturing process, a component within the fuel pump could swell causing the fuel pump to become inoperative.
Due to a defect during assembly, incorrect fasteners may have been installed on the steering linkage joints and could become loose over time. If this occurs, the vehicle may experi…