Every safety recall published by the Australian government, searchable and filterable.
A batch of throttle cables was delivered to the production line without a polymer sleeve. The absence of this polymer sleeve may restrict the movement of the cable to control the a…
In some instances, the Air Conditioning Drain Tube may become blocked causing the water to overflow in the area where the Airbag Control Module is located. Consequence: Should wate…
The adhesive strenth between the left and right rear vent window and its forward mounting hinge may be insufficient. Under certain conditons this may lead to the window pane detach…
The electrical connector between the heated windscreen and the vehicle wiring harness could experience a thermal overload under certain conditions. Should this occur heat damage to…
This campaign consists of inspecting the fuel return pipe and the engine styling cover (soundproofing) for traces of wear on the pipes from the cover.
This campaign consists of inspecting the fuel return pipe and the engine styling cover (soundproofing) for traces of wear on the pipes from the cover.
In rare cases the bonnet may require replacing if the striker is found to be insufficiently secured.
Poor surface plating of the stay welded to the Automatic transmission oil feed tube assembly may allow corrosion to develop. An ATF leak may occur at the corroded section and in th…
MAN Automotive Imports Pty Ltd have been made aware of a potential safeguard with the parking brake by the air distributor check valve if there is a loss of pressure in the supply…
Selected Jayco caravans and campers that have been manufactured with accessories that may have the weight of the van on the cusp of the limit for a 1450kg axle will be replaced wit…
Due to programming of the ABS (Anti Lock Braking System) there is a possibility that the braking force may be slightly degraded on completion of ABS activation. In situations where…
On affected units, polystyrene-derived debris may be lodged in the oil passage. The debris could block or reduce oil flow which may result in camshaft seizure and engine lock, crea…
In the subject vehicle, the brake fluid low level warning light ('Visible Indicator' in ADR35/02 S4.2) does not illuminate when the brake fluid level is below the minimum line in t…
In some instances, the intermediate shaft which connects the steering column to the steering rack may become disconnected. If the intermediate shaft becomes disconnected, this may…
Vehicle owners may experience reduced performance of the park brake over time and may also see visible signs of a minor oil leak such as oil spots under the vehicle. The loss of pa…
On affected vehicles the torque of the steering shaft upper joint fixing screw requires tightening. Consequences: The joint fork could eventually break with consequences on the ste…
Some of the upper engine cases in the affected model range may have porosity in the aluminium casting. This porosity occurs in the vicinity of a pressurised oil passage just above…
Engine running poorly. Consequences: Poor driving performance
A loose fitment of the tailgate strut ball joints. Consequences: Tailgate rattle.
Possible incorrect engine control settings.
Conformity of fitting of the windscreen side trim. Consequences: In rare cases the fitting of the trim on the windscreen side trim may come loose.
Loose fitment of tailgate spoiler. Consequences: It may fall off.
A loose fitment of the tailgate strut ball joints. Consequences: Tailgate rattle.
Loss of communication from the steering wheel mounted controls.Consequences: In rare cases there may be a loss of communications with the controls.
Due to an inconsistent tolerance applied during production dimensional variation in the fuel pump seating area of the fuel tank may result in fuel leakage during refuelling when th…