Every safety recall published by the Australian government, searchable and filterable.
Due to a software programming fault, the engine may not restart after entering idle stop mode until the vehicle is restarted using the Start/Stop button.
The Smart Brake Support (SBS) system may falsely detect an object in front of the vehicle, which may initiate the automatic brake function.
Due to an incorrectly routed section of the wiring harness, the transmission wiring harness may short circuit and shift the transmission into the neutral gear.
Due to an error in the Frontal Collision-Avoidance Assist (FCA) software, the braking assist function may fail when the vehicle approaches a stationary vehicle or a pedestrian.
The motorcycles may have a defect in the 10 amp circuit breakers.
In extreme wet weather conditions (such as snow, ice and salt spray), the electric vacuum pump may corrode and deteriorate brake performance, which will illuminate the brake warnin…
A section of the chassis may have a crack on the welded section of the diagonal cross member of the steering box cradle.
The wheel rims on the vehicle do not meet strength specifications. If an affected vehicle hits the kerb or crosses speed humps or uneven road conditions at high speed, the wheel sp…
Due to incorrect wiring, all lights on the trailer become inoperative when the vehicle ignition is off, including the hazard and brake lights.
Due to incorrect wiring, vehicles fitted with the tow bar wiring harness may experience the hazard warning lights to become inoperative when the key is removed from the ignition.
The Quickshifter Assembly, TSA body may come into contact with the gear change Clamp Linkage Assembly, potentially impeding a smooth “assisted” gear change, resulting in a missed g…
Due to improper assembly, the battery's negative cable terminal may break.
The tightening torque of the spare wheel support mountings might not meet specifications, which may cause the spare wheel to become loose and risk falling off.
The electro-hydraulic control unit (EHCU) software may respond incorrectly to a faulty rear wheel speed signal by activating one of the rear brakes.
Over time the aluminium positive crankcase ventilation (PCV) valve may fracture, allowing the engine to draw an increased amount of engine oil. This may cause excessive exhaust smo…
Incorrectly fastened wheel arch covers could come loose over time and potentially detach from affected vehicles.
Frequent use of the hazard lamps may cause the fuse to blow and the hazard and turn signal lamps to become inoperative.
The attachment of the trim divider at the rear door windows might not meet specification.
The self-adjustment mechanism within the brake caliper housing may be defective, resulting in reduced or lost braking performance when applying the parking brake or service brake.
The gear position switch used may provide an inaccurate signal, which can lead to an incorrect gear being displayed in the rider display.
The outlet exhaust pipe is incorrectly positioned, which may cause heat damage to some braking system components, such as the service brake relay valve, which may melt.
Vehicles have been supplied with incorrect information in the Owner Manual in regards to the installation of ISOFIX child restraint system.
Vehicles have been supplied with incorrect information in the Owner Manual in regards to the installation of ISOFIX child restraint system.
The drag link jam nut may loosen and may result in the drag link separating from the adjuster sleeve.
A cross-member at the base of the rear seat frame may have been improperly welded to the seat frame.