Every safety recall published by the Australian government, searchable and filterable.
During the assembly process, small strands of loop wire were fitted to the fuse panel to test the electrical circuits at buils completion. On some vehicles it has been found that t…
The handlebar clamp bolts may have been tightened to the incorrect torque.
If the electrical earth wire that is fitted underneath either front seat becomes detached, an electrostatic charge can cause the side airbag to deploy when the car is stationary an…
Should a failure of the brake system occur, the affected vehicle may become hard to control (pull severely to one side, depending on which system fails) under a heavy breaking situ…
There is a possibility that the high pressure fuel pipe clamps may loosen due to engine vibration, resulting in fuel leakage.
The fuel tank may develop a stress crack due to metal fatigue. This could result in fuel seepage from the tank.
There have been some instances of the 8mm brake pipe detaching at certain locations on this vehicles resulting in a loss of air pressure in the breaking system.
A rear view mirror is improperly located and it is not possible to adjust the mirrors towards the rearward field of vision.
The throttle cables may contact the tunnel portion of the fuel tank. Should this occur the cables could wear through the fuel tank causing a fuel leak.
The fuel pump retaining ring may have been improperly installed. This may cause some leaking of fuel from the fuel tank in certain circumstances.
A possible defect exists in an engine camshaft sensor component. If the sensor does malfunction, the sensor may melt generating possible odour and visible smoke and may subsequentl…
The B+ terminal may be in conflict with the starter motor solenoid in the cars concerned.
A possibility of a thermal malfunction on water seperator bowl with heater. There is a risk of overheating due to low fuel level in combination with a faulty thermostat in the wate…
In the subject vehicles, the headlamp dimmer switch contact points may overheat due to high internal electrical resistance caused by residue build up on the surface of the contact…
Safety valve may not operate at the required relief pressure.
The turbocharger coolant hose was manafactured from a material that is not considered durable in this location. In the worst case the hose may deteriorate to the point of allowing…
Under certain operating conditions the left hand rear door may be opened from the inside of the vehicle when the child-lock is engaged.
A potential manufacturing defect in the housing of the airbag and may affect the deployment or operation of the passenger airbag if it is activated.
A crack may develop in the epoxy resin of the ignition coil from the effects of engine heat, resulting in a potential open circuit or poor connection of the secondary coil winding…
The airbag control system may not operate in accordance with the manufacturers' specifications.
The airbag control system may not operate in accordance with the manufacturers' specifications.
During the manufacturing process,the fuel pump retaining tabs holding the fuel lines were damaged in some of the involved vehicles.Over time,this could cause the fuel lines to loos…
The fuel pump may break as a result of a production fault. As a result the pump housing is not tight and a diesel fuel leak my occur.
Fuel may leak from the filler neck when the fuel tank is near or at its full capacity due to the deterioration of the filler neck sealant compound.
The seat occupancy detectors may intermittently be unable to reliably detect that the seat is occupied, and the following components will not be activated when required:E 60: front…