Every safety recall published by the Australian government, searchable and filterable.
The main switch may be exposed to water spray due to battery box positioning.
Vehicles have been manufactured with door latch mechanisms with insufficient heat treatment.
The airbag system occupant restraint control (ORC) module may experience a front airbag and/or seatbelt pre-tensioner inadvertent deployment.
Due to software concerns within the engine and transmission control units, the engine may stall when coasting to a stop.
The Compliance Label does not comply with the marking requirements in either ADR 62/02 or AS4177.1. Specifically the towing loads do not match the specifications for 16MY MQ Triton…
A deviation has been detected in the joint between the two halves of the spring brake chambers in the parking brake circuit. The deviation may cause the spring brake chambers to sp…
A deviation has been detected in the joint between the two halves of the spring brake chambers in the parking brake circuit. The deviation may cause the spring brake chambers to sp…
A deviation has been detected in the joint between the two halves of the spring brake chambers in the parking brake circuit. The deviation may cause the spring brake chambers to sp…
The seat belt in one of the front seats may not be properly connected to the outboard lap pretensioner.
The battery cable may be incorrectly positioned and may contact the wiper arm. If this occurs it may result in a short circuit resulting in the failure of the wipers.
The brake timing does not meet legislative requirements due to the incorrect routing of pipes.
The Air Conditioning (A/C) hose may have been misrouted during the manufacturing process. The A/C hose may come in contact with the engine exhaust manifold. Prolonged A/C hose co…
The front brake caliper may exhibit some fluid leakage due to an uneven piston seal surface, caused by entry of the outer coating treatment into the piston bore during production.
The front brake caliper may exhibit some fluid leakage due to an uneven piston seal surface, caused by entry of the outer coating treatment into the piston bore during production.
Selected Honda Civic Hatch vehicles were installed with owner's manuals specified for EU vehicles.
On a number of vehicles, the front brake pads display excessive amounts of thermal expansion, resulting in the brakes dragging under certain conditions.
ES350 & ES300h vehicles equipped with Pre-Collision System (PCS), there is a possibility that the system could interpret a steel expansion joint or plate that crosses the road sur…
It has been found that some vehicles with a vehicle jack that does not comply with the mandatory standard for vehicle jacks AS/NZS 2693:2007, due to incorrect labeling.
All Foton Tunland vehicles have been supplied with a vehicle jack that does not comply with the mandatory standard for vehicle jacks AS/NZS 2693:2007, due to incorrect labeling.
Inappropriate length rivets may have been supplied with the accessory soft tonneau cover kit. Some kits contained 14mm long rivets instead of the required17mm length.
The Rear Brake Master Cylinder piston seal could develop a tear.
The sliding electrical contacts in the driver's side power window master switch may have been lubricated with insufficient quantity of grease. During normal operation, wear residue…
Maserati is recalling Quattroporte (M156) vehicles to replace the alternator-starter wiring harness. The protective sealing cover on the electrical connection of the engine power c…
The side stand for supporting the parked motorcycle in an upright position could break at the joining weld.
There is a possibility that the low pressure fuel line under the hood can leak at the connection point