Every safety recall published by the Australian government, searchable and filterable.
The steering wheel boss, which is connected to the steering column, may not have the appropriate strength.
On affected vehicles, there may be some partial long-term wear due to rubbing of the starter motor harness.
A particular component may wear out and cause fuel leakage at the cylinder head.
Incorrect fitment of the driver's side footwell trim panel may cause interference with the accelerator pedal travel.
In certain conditions, the power steering high pressure pipe could be damaged, which may result in a small fluid leak.
Incorrect torque applied to the damper p-clip fasteners may have damaged the fasteners, allowing the p-clips to become loose.
The vehicle may suffer reduced brake performance and/or a spongy low brake pedal due to a sticky valve within the Electronic Brake Control Module (EBCM).
The vehicle may suffer reduced brake performance and/or a spongy low brake pedal due to a sticky valve within the Electronic Brake Control Module (EBCM).
The vehicle may suffer reduced brake performance and/or a spongy low brake pedal due to a sticky valve within the Electronic Brake Control Module (EBCM).
The vehicle may suffer reduced brake performance and/or a spongy low brake pedal due to a sticky valve within the Electronic Brake Control Module (EBCM).
Certain vehicles may have an incorrect draglink fitted. Once this draglink has been modified, the product strength is greatly reduced, which leads to material fatigue and could res…
Defective secondary spring on the pedal return mechanism.
Some engine crankcases may have a casting flaw which could allow engine oil to leak.
Due to the gap between the rear brake pedal and the guard, small stones or other road debris may become trapped between the brake pedal and the guard.
The tow bar assembly fitted to affected vehicles may develop weld fracturing around the towbar tongue.
It has been discovered that the gaskets listed contain a small amount of bonded asbestos fibre.
It has been discovered that the gaskets listed contain a small amount of bonded asbestos fibre.
The product's identification plate displays the incorrect vehicle category. In addition, the headlamp may not meet regulated requirements and the noise label fitted to the scooter…
The low pressure fuel lines in some EPA04 MBE 4000 engines may leak fuel.
On some vehicles, there is a possibility that the fuel hose that connects the main fuel supply line to the engine may have become wrinkled during manufacture. This could result in…
The side-stand of the motorcycle may bend, and under extreme circumstances, break in the area near the rotation pivot.
The following defects may occur:Exhaust Valve Bowden Cable Heat Protector: Under extreme conditions, the plastic protector could melt or burn, producing smoke and noxious fumes.St…
At temperatures below -20 degrees celsius, the glass-sliding sunroof may suddenly break.
The fuel feed lines may leak fuel.
There is a chance that the battery earth cable dimensions are not correct resulting in excess tension to the cable, possibly causing the cable to break.