Every safety recall published by the Australian government, searchable and filterable.
During production it is possible that the seat belt anchor bolts at the B pillar and seat base may have received an incorrect torque setting. In the case of an incorrectly tensione…
There is a possibility that the front seat belt buckles may have been damaged during manufacture.
The accelerator pedal on your vehicle may stick during vehicle operation.
In vehicles where this condition exists, it is possible for the module to experience from minor distortion to considerable melting of the plastic around the HXFS fluid chamber. In…
The plastic material coating the outer race of the power steering pump belt tensioner pully is of insufficient durability.
Certain 2010 model year Subaru Liberty and Outback vehicles may experience a wiring fault within the steering roll Connected.
Isuzu Motors Japan have identified that the trailer parking brake air line may leak.
The ball joint and cylinder pin on the gear shift lever may be mounted with an incorrect torque which can lead to the ball joint coming loose.
Investigations have identified early wear on the the belt tensioner.
During Manufacture the bolts attaching the ball joints to the front suspension upper arms on either side of the vehicle may not have been installed with sufficient tightening torqu…
The transmission fluid in your vehicle may overheat under certain driving conditions. Continuous operation under these conditions may cause the transmission fluid to boil over and…
There may be some Focus TDCi vehicles equipped with the DW10 (Diesel) engine that may not have had an exhaust heat shield fitted.
On certain Lexus LS460 and LS600hL vehicles the Steering Control ECU programming for the Variable Gear Ratio Steering (VGRS) system can result in the steering wheel becoming off-ce…
A concern has been detected relating to the installation of heavy 'Steel bull bars' and accessory devices such as winches being fitted to the front of these European models. In hig…
The affected carpet mat in the driver's footwell may interfere with the accelorator pedal.
In rare cases, stress generated by the back and forth movement of gasoline inside the fuel tank during lateral and longitudinal accelerations, accompanied by vertical vibration cou…
In some instances the carburetor return spring has failed.
There is a possibility of the wiring harness coming into contact with the cooling fan blade causing damage to the harness.
Certain MY10 Liberty and Outback vehicles fitted with the CVT may experience an oil leak from a faulty oil cooler hose.
On certain BT-50 vehicles, the bonnet striker may receive more lateral input than expected when driven in severe conditions like a rough road and/or if the bonnet fitting condition…
On some V240 vehicles, there may be a manufacturing defect in the handbrake assembly that could cause the handbrake to disengage.
A production condition during the wheel and tyre assembly process may have resulted in a tear in the tyre sidewall.
The strength of the wire clip retaining the oil pressure pipe to the clutch master cylinder may be insufficient allowing the pipe to become disconnected during clutch operation.
Some Jayco Pop Tops may have been manufactured with the incorrect tyres based on the overall weight of the van.
A manufacturing defect in the fuel pressure line may result in a fuel smell and/or fuel seepage. Since the fuel lone is working under a constant pressure, some seepage can, within…