Every safety recall published by the Australian government, searchable and filterable.
Due to an oversight in the checking process of the front and rear wheel rim and hub assemblies at the factory, some nuts were identified with insufficient tightening torque. If lef…
Where the battery voltage is abnormally low the ABC ECU may be out of conformity in relation to the specifications required by the manufacturer. This non-conformity may in rare ca…
Tyres within this production range may present a risk of reduced robustness in the bead area which may lead to a rapid loss of air pressure.
Some units may have had the bolts that secure the rear disc to the rim tightened incorrectly.
Due to improper folding of the front passenger airbag a certain gap between the internal folded airbag and bag holder might be realised.
Due to an oversight that may have occurred in production some vans were not fitted with rear mudflaps in accordance to the certification specifiction.
There is the possibility that in isolated cases the driver's airbag may not deploy as intended if triggered in an accident.
Vehicles may suffer from a fuel system leak due to loose fuel pipe clips and/or damaged fixing bolts.
An excess of material in the return pipe may restrict the flow of fuel back to the tank.
The battery caddy bolt (retaining the battery in place) may loosen under normal riding conditions and, should this occur, the battery may shift such that its terminals may contact…
Incorrect Gross Vehicle Mass stamped on the compliance and ID plate. The plates indicate that the truck has a GVM of 24,000kg instead of the approved 22,500kg.
Incorrect Gross Vehicle Mass stamped on the compliance and ID plate. The plates indicate that the truck has a GVM of 24,000kg instead of the approved 22,500kg.
A temporary fault in the greasing system for the sealing ring on the brake booster could lead to the sealing ring being subject to wear. In unfavourabale situations, the sealing ri…
The lock mechanism of the reclining adjuster fitted to the second row of seats has not undergone heat treatment processing.
Ensure the spare wheel carrier has a 3rd bolt and nut fitted to ensure better fastening of the rim and tyre to the spare wheel carrier.
Fuel tank
The control cam of the steering wheel lock may break in individual cases.
The rear emergency door fitted to these buses may be difficult to open due to ingress of dust into the sliding latch lock assembly.
Incomplete information stamped on compliance plates. The incomplete information involves seating capacity being left blank.
A condition can occur where an incorrectly manufactured Rear Seat Belt Buckle has been fitted to a range of VE & WM vehicles.
The air filter mounting screw/s may come out and lodge in the throttle valve. If this happens the vehicle does not reduce engine speed.
There is a possibility that an oil leak may develop due to the potential for the subject rubber oil cooler hoses to split under certain operating conditions.
A concern has been identified on the Relay Box Bracket for some D40 Navara vehicles with Non ABS specification. The Relay Box Bracket for D40 Navara with ABS specifiction has been…
A concern has been identified on the Relay Box Bracket for some D40 Navara vehicles with Non ABS specification. The Relay Box Bracket for D40 Navara with ABS specifiction has been…
The clutch pedal pushrod on a number of vehicles may break and allow clutch engagement when the pedal is depressed. This can increase the vehicle's stopping distance and/or cause e…