Every safety recall published by the Australian government, searchable and filterable.
Insufficient tightening torque has been applied when mounting connection rail C55 which connects the +24V supply between the chassis to the cab. The absence of the spacer ring on t…
The Left Rear and Right Rear brake pipes may have been connected to the ABS Hydraulic unit in reverse sequence. The secondary brake tube between the master cylinder and the ABS Hyd…
There have been instances of the fuel pipes on engines with mechanical injector pump being incorrectly clamped.There have also been instances of the routing of the fuel pipes being…
A possibility exists that the front bumper beam may have insufficient strength when subjected to high towing load 'recovery' techniques(snatch strap) from soft ground such as sand,…
Due to a crease or crack that may have occured in production during the fitment of the fuel vapour vent hose to the fuel tank,a fuel odour or even leakage may occur when the tank i…
There have been instances of leakage from the return fuel pipe on ethanol-powered buses with DS19E engines.
During the manufacturing process,the fuel pump retaining tabs holding the fuel lines were damaged in some of the involved vehicles.Over time,this could cause the fuel lines to loos…
During product monitoring on R1200GS,R1200RT and R1200ST motorcycles it has been determined that there is the possibility of small objects such as a pebble, for example, or the cov…
Under the influence of increased loads the steering arm mounting brackets may have a reduced service life. This is particulaly so if the steering end stop limit has not been adjust…
Moisture entering the Body Builder's electrical centre.
This campaign consists of fitting a strengthener plate to the removable towing ring rear support. In the exceptional situation where the rear support has been strengthened it may c…
Where an interrupted earth cable can make the current from the cabin to find its way back to the battery through the steering shaft.
Possible risk for the Light Control Module (LCM) to overheat.
On the top of the tyre placard states correct usage of a 185/60R15-88 (G) type tyre. However on the bottom placard incorrectly refers to a different load and speed rating of (93) (…
The television may continue to operate if the telephone is used while the vehicle is stationary. The television operation could distract the driver and is a breach of the ADRs.
The anti-theft wheel locking bolt kit needs to be replaced to eliminate the risk of damage to the bolts making it more difficult to remove the wheel using the anti theft key.
Turbocharger to be replaced on New R Series Trucks with D16 engines 500 & 580hp. The turbocharger has caused increased blow-by and high crankcase pressure during exhaust braking, w…
1.Non-compliance with part of clause A 6.5.8 of Australian design rule 13/00, Installation of lights & light signalling devices, which requires telltale behaviour on turn signal ma…
The possibility exists for the automatic transmission shift lever guide plate screw to become loose and possibly fall out, resulting in the automatic transmission shift lever movin…
There is a possibility that the tyre bead may have been damaged during the process of mounting the tyre on to the wheel.
The fuel pump may break as a result of a production fault. As a result the pump housing is not tight and a diesel fuel leak my occur.
Fuel may leak from the filler neck when the fuel tank is near or at its full capacity due to the deterioration of the filler neck sealant compound.
The frame stay may crack at the point where the main stand attaches to the frame.
Improper installation structure of the passenger seat to the motorcyle, the passengers weight shift on the tandem seat can possibly cause the seat's mounting bolt to loosen.
The turbocharger has caused increased blow-by and high crankcase pressure during exhaust braking, which in turn caused over revving of the D16 engine.