Every safety recall published by the Australian government, searchable and filterable.
The airbag control system may not operate in accordance with the manufacturers' specifications.
The fuel filler pipes fitted to some models of RA Rodeo are designed and manufactured from a non-electrically conductive material. During filling of the petrol tank, an electrosta…
The rubber component of the rear engine mounts may crack during normal operation. Both front and rear engine mounts will be replaced. 47 vehicles will also require replacement of…
The rubber component of the rear engine mounts may crack during normal operation. Both front and rear engine mounts will be replaced. 47 vehicles will also require replacement of…
Owing to a possible combination of causes of the spot welding condition, the spot welds between the hood lock support and the hood inner panel may separate. If the vehicle is drive…
There is a possibility of the ABS sensor cable sagging into a loop in the vicinity of the front left brake caliper when disassembly work is carried out (tyre change, for example).…
A condition may occur where the front brake hose can slide out from the retaining bracket on the front strut.
A condition may exist with certain functions of the Sensotronic Brake Control (SBC) on a number of type 230, SL Class and 211, E Class vehicles.
The defect appears to be in the mounting face of these rims being bent during manufacture and allowing the wheel nuts to loosen as the trailer is towed on the road. This can cause…
Production mounting of the hub cover 1760065 has been unsatisfactory during the period from February to March 2005. Manufacture of the hub cover has been of sub standard quality wi…
Subsequent to the initial recall notice, it has been found the remedy has insufficient safety margin to correct the problem. This applies to XVS650 and XVS1100 models only. The fac…
Replacement of Plush Velour Floor Mats if fitted to vehichle, to eliminate the possible risk of the floor mat coming into contact with the accelerator pedal.
Position of the side indicator lights on the bonneted series vehicles does not comply with the Australian Design Rules.
Incorrect approval number stamped on the compliance plate.
Potential exists for a park brake bracket within the rear brake assembly to crack, particularly where the parking brake is used frequently or with excessive force.
Potential exists for a park brake bracket within the rear brake assembly to crack, particularly where the parking brake is used frequently or with force. Should the component crac…
The No 1 rear suspension arm may have been incorrectly welded. In instances where the weld is not to specification the arm may break at the bush housing weld area and in the worst…
There is a possibility that the front suspension lower ball joint may have been scratched. If the vehicle is operated for an extensive period in this condition, excessive wear of…
The sidestand on some vehicles may malfunction.
Oscillation of the motorised throttle valve may cause breakage of the throttle stop. The engine may be placed in the emergency program phase (limp mode) with a possible reduction…
Ball stud bracket located on rear liftgate window could rotate out of position on the glass & cause window to drop. Hinge which attached liftgate window to liftgate body may separ…
There is a possibility that the automatic transmission gear selection shift lever could come loose and fall out. This may result in the driver moving the shift lever into an unwan…
Under certain highway driving conditions, vehicle steering characteristics and vehicle directional stability can be affected due to rear tyre characteristics. Note: i.e. tyre trea…
The MIL (Malfunction Indicator Lamp) will fail to illuminate when an automatic transmission OBD related malfunction occurs. However, the D indicator will flash if Automatic Transm…
Due to possible caulking on the cable tip at the centre drum being improperly shaped, the tip may get caught in a stanted direction against the groove in the parking brake lever du…