Every safety recall published by the Australian government, searchable and filterable.
Either of the flexible hoses carrying fuel between the engine and the fuel cooler, and the engine and the body can leak.
Due to engine vibration the MAF (Mass Air Flow) Sensor connecting wire may cause an intermittent electrical connection failure leading to possible engine stalling.
Excessive brake pedal travel when engine bay temperatures are below freezing.
Compliance plate stamped with incorrect date format for February 2001.
Possibility that some vehicles may have a condition wherein moisture and/or mud can enter the lower lateral arm ball joint via a split in the ball joint dust cover or via the ball…
Damage to the steering system from contamination.
The throttle cable grommet is susceptible to failure. If the grommet is damaged and not replaced the accelerator may be rendered inoperative resulting in a sudden loss of power.
One or both of the front sway bar links may break in freezing conditions.
All electronic throttle pedal assemblies manufactured by Felsted Products prior to September 2000 may contain return springs that have the potential to break in service. The throt…
The brake pedal pivot and roller pin retaining clips may not have been correctly installed. If this occurred, the pins might become dislodged, resulting in an inability to apply t…
The ball stud and socket assemblies on certain tie rods may contain bearing surfaces that have a less than specified case depth and/or hardness causing the socket assemblies to wea…
Possible damage to surface of the left hand rear flexible brake hose.
Possible damage to surface of the left hand rear flexible brake hose.
The clutch mechanism under severe loads with partial engagement will shudder and can crack the outer carrier. This can then break into large pieces that come loose inside the casi…
Loss of vehicle braking due to power brake vacuum pump drive pin becoming defective under extreme and continuous braking operation.
Due to cracking on the drain pipe at the inside bottom of the fuel tank sustained from vibrations some units may have fuel leaking; and due to malfunction of the fuel level sensor…
Possible failure of the dimmer control for the instrument panel lights. A transistor may fail due to high temperatures generated when the instrument panel dimmer light is operativ…
In the case of a side collision, the deployment of the side airbag may not meet Volvo specification.
Improper welding procedure in the production process of the brake pedal assembly.
Potential for a fuel leak to develop on fuel gauge sender units fitted to these model motorycles.
An internal seal within the 136-8537 Brake Booster may be defective which may allow the brake fluid to drain from the brake reservoir back to the hydraulic tank resulting in failur…
8mm threaded Child Restraint Anchors have been fitted (in lieu of specified 5/16' UNC threaded anchor points) in a number of vehicles.
Front seatbelt buckle latching mechanism may not have received sufficient heat treatment during production.
Possible fatigue failure on the steering cylinder piston rod.
The frame down tube may possibly crack at the lower area of the head gusset which could cause the rider to lose control of the motorcycle.