Every safety recall published by the Australian government, searchable and filterable.
Throttle sticks at idle.
There is a potential for loss of throttle control during use.
The fuel tank upper panel may crack as a result of expansion and contraction of the fuel tank which occurs due to internal pressure changes. In the worst case fuel may leak from t…
There is a possibility that the electrtical wiring harness for the fuel pump and fuel gage assembly may become damaged on some vehicles due to insufficient clearance to the underbo…
The subject vehicles have a powertrain control module (PCM) that may allow the vehicle to exceed the design intent top speed. At these extreme speeds, the vehicle may be capable of…
Possible fuel tank leakage from cracked seam.
Water can ingress into the automatic gearbox breather pipe causing the park lock function to corrode and become inoperative, and could lead to the vehicle rolling away.
The power brake vacuum pump drive pin may become defective under extreme and continuous braking operation resulting in loss of vehicle braking.
Due to insufficient strength of the centre support bearing housing on the propeller shaft, the bearing housing may possibly break under frequent hard acceleration from low speed.
Potential fatigue cracking in steer arms.
The ACE system high pressure hose may fracture and leak fluid due to the absence of an attenuator spring within the hose assembly.
The mounting brackets could fracture or break, which could result in a loss of steering and control of the motorcycle compromising the rider's safety.
If the bolts holding the exhaust system become loose, the bracket holding the mufflers can break resulting in mufflers falling loose from the motorcycle. This can damage or pull l…
Potential defect with the lower steering column pitch bolt torque.
Defect may exist with the Haldex Park Brake Valve.
The brake piston rod that activates the service brakes may bend and fracture, causing a loss of brakes.
TRW tie rod ends may wear prematurely.
Due to a production fault it is possible that the upper and lower part of the steering column may not have been assembled correctly which could result in the steering shaft becomin…
The outlet pipe of the fuel filter may bend; and also the right angle joint of the fuel feed tube may split, resulting in leaking fuel with a possibility of fire.
The bracket on which the rear brake caliper rests may bend which could result in damage to the threaded brake line connection and a leak at the rear caliper resulting in failure of…
Cable ducting has sharp edges that can damage electrical cables resulting in an electrical short circuit.
Possibility of loosening or breakage of spokes in the rear wheel.
Defective drag link and ball socket steering components have not undergone correct hardening procedures during manufacture and thus can wear prematurely. This can lead to the comp…
A possibility exists that vehicle braking imbalance may occur due to incorrect specification tyres fitted to the vehicle (Continental 195/55R15) which do not comply to the vehicle…