Every safety recall published by the Australian government, searchable and filterable.
Rear Seatbelts May Not Fully Meet The Requirements Of ADR 4/01.
Potential Problem Exists With The Autolive Seatbelts Pd012 And Pd013.
Seats Assembled With Unprotected Wiring . The Seat Cushion May Deflect Enough To Crush The Wiring Harness And Expose Bare Wires To The Motor Bracket Resulting In A Short Circuit C…
The Lift Cylinder Rod Could Experience A Weld Failure.
A Defective Internal Thread In The Oil Cleaner Housing May Cause The Shaft In The Oil Cleaner To Come Loose And Then The Oil Pressure Forces The Shaft, The Rotor Bowl And The Cover…
Possibility That The Engine Cam Sprocket Bolt Could Lose Their Clamp Loads And Or Break, Thus Causing The Engine To Quite Running Or Run Erratically Before Quitting.
Deterioration Of The Bonnet Liner May Occur Allowing The Non-rigid Sound-deadening Material To Sag So That It Comes Into Contact With Moving Components Of The Throttle Mechanism.
The Centre Seat Belt May Have A Faulty Tongue And/or Mounting Plate Which May Fail Due To Insufficient Strength.
On The Sash Guide Of The Front Seat Belts An Incorrect Welding Process May Have Occurred On The Weld Nut For The Bolt Used To Secure The Shoulder Anchor Point And May Not Guarantee…
May Not Fully Meet The Requirements Of ADR 4/02. The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Range Specified By This ADR.
Do Not Fully Meet The Requirements Of ADR 4/01. The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Range Specified By This ADR.
The Rubber Cover For The 30 Connection At The Starter Motor Solenoid Has Been Of An Incorrect Material Which Is Conductive And May Cause A Fire If The Starter Cables Are Mounted I…
Do Not Fully Meet The Requirements Of Adr4/01. The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Range Specified By This Adr.
Do Not Meet Fully The Requirements Of ADR 4/01. The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Range Specified By This ADR.
Do Not Meet Fully The Requirements Of ADR 4/01. The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Range Specified By This ADR.
Do Not Meet Fully The Requirements Of ADR 4/01. The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Range Specified By This ADR.
Do Not Fully Meet The Requirements Of ADR4/01. The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Range Specified By This ADR.
Do Not Fully Meet The Requirements Of ADR 4/01. The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Range Specified By This ADR.
Do Not Meet Fully The Requirements Of ADR4/01. The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Range Specified By This ADR.
The Front Tyre Fitted To These Vehicles May Deflate.
The Screw Joints For The Spare Wheel Carrier May Fail Due To Screw Joint Settling And The Torque Decreasing.
A Bolt Retaining The Clutch And Pedals May Not Have Been Sufficiently Tightened - Could Cause Loss Of Braking Control.
New Compliance To ADR 4/01 Clause 4.6 4.5Seat Belts Fitted At Incorrect Angle.
The Seat Belt Retractors Do Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Ranged Specified By ADR 4/01.
May Not Comply With ADR 4/01. The Seat Belt Retractors May Not Allow Easy Withdrawal Of The Webbing Through The Full Angular Ranged Specified By The ADR.