Every safety recall published by the Australian government, searchable and filterable.
Seat Belt Inertia Mechanism Jams Making It Difficult To Withdraw The Belt Which Become Uncomfortably Tight In Use.
Front Wheel Brake Components May Brake From Vibration Caused By Bump Or Severe Road Corrugations: Loss Of Front Brakes.
Incomplete Riveting On Driver's Seat Height Adjuster Mechanism: Only Vehicles Manufactured 27/7/88 - 31/8/88.
Possible Defect Of The Brake Pedal Box Assembly And Rear Brake Line: Vehicles To Be Checked And/or Corrected.
Steering Bevel Gear Assembly May Have Water Contamination Resulting In Rust Causing A Potential Steering Problem.
Sudden Acceleration May Cause Throttle To Foul Causing Motor To Continue Revving.
Some Wheels Been Incorrectly Manufactured Preventing Wheel Nuts From Being Fully Tightened: Wheel Studs May Fail.
Transverse Weld At Skid Plate Connection To Main Beam Structural Members Causing Cracking And Ultimate Failure.
Rubber Seal Rings On Fuel Injectors May Leak Resulting In Fuel Escaping Into Engine And Ignited On Exhaust System.
Ball Stud Used In The Steering Assembly Does Not Meet Required Specifications.
Premature Deterioration Of High Mounted Rear Stop Lamps Switch: Lights Will Remain Continuously On Or Not Work At All.
Premature Deterioration Of High Mounted Rear Stop Lamps Switch: Lights Will Remain Continuously On Or Not Work At All.
Fuel Hose May Crack Causing A Possible Fuel Leak With Consequent Potential For Fuel To Ignite.
Steering Shaft Universal Joint Retaining Bolts May Loosen Causing Sterring Column To Disconnect From Steering Box.
Fuel Line Couplings Not Fully Connected And May Unlock Or Separate During Vehicle Operation Causing Fuel Leak.
Possible Malfunction Of Front Screen Wiper.
Reduced Design Strength In Front Axle.
Reduced Design Strength In Front Axle.
Rear Braking System May Lose Effectiveness.
There Is The Possibility Of A Fault In The Front Windshield Wiper Motor Which May Render It Inoperable.
The Front Driveshaft Flange Bolts May Loosen And Separation Can Occur.
Three Of The Four Front Seat Mounting Bolts Are Of A Lower Than Specified Grade Bolt.
Three Of The Four Front Seat Mounting Bolts Are Of A Lower Than Specified Grade Bolt.
Possible Incorrect Assembly Of Steering Column.
Nylon Tubing Used For The Hydraulic Override Brake Hose Does Not Perform To The Specifications Laid Down In Adr 7/00.