Every safety recall published by the Australian government, searchable and filterable.
Door Locks Do Not Allow Door To Shut Properly.
Shifter Forks Might Fracture Causing Transmission To Malfunction And Possibly Cause Rear Wheel To Lock Up.
The Front Wheel Hub Assembly May, Under Certain Severe Conditions, Crack.
Rear Seat Back Latch/fuel Filler Vent Line/ext. Sunvisors/rear Axle Wheel Studs: Not Secure/may Sever/dislodge/fail.
Rear Seat Back Latch/fuel Filler Vent Line/ext. Sunvisors/rear Axle Wheel Studs: Not Secure/may Sever/dislodge/fail.
Rear Seat Back Latch/fuel Filler Vent Line/ext. Sunvisors/rear Axle Wheel Studs: Not Secure/may Sever/dislodge/fail.
Rear Seat Back Latch/fuel Filler Vent Line/ext. Sunvisors/rear Axle Wheel Studs: Not Secure/may Sever/dislodge/fail.
Top Ram Retaining Nut Can Become Worn And Loose Possibly Causing A Complete Ram Separation.
Corrosion Between Zinc Coated Bracket And Aluminium Fuel Filter Canister May Penetrate Canister And Cause Fuel Leakage.
Clamps On Sleeve Connecting Fuel Filler Neck To Fuel Tank Not Tightened Correctly - Xf Falcon Utility And Panel Vans.
Vehicles Fitted With Fruehauf Axles And Bendix Assembled Linings And Shoes May Have A Defect In Brake Asemblies.
Vehicles Fitted With Fruehauf Axles And Bendix Assembled Linings And Shoes May Have A Defect In Brake Asemblies.
Hard Acceleration Of Hub Damper May Cause Breakage Of Other Cycle Parts Leading To Loss Of Control Of Vehicle.
Vehicles Fitted With Fruehauf Axles And Bendix Assembled Linings And Shoes May Have A Defect In Brake Asemblies.
1987-1988 Models Can Develop Vibrations & Could Cause Engine To Overheat & Brake Failure.
Potential For Loss Of Front Brakes.
The Fuel Filler Neck To Fuel Tank Sleeve's Positioning & Clamp Is Not To Specification & Could Lead To Fuel Leakage.
Improperly Installed Steering Universal Joint May Cause Loss Of Steering.
The fuel filter could leak under certain circumstances and fuel may ignite.
If Fuel Tank Is Overfilled Fuel Vapour May Escape From Charcoal Canister & Ignite On Exhaust System.
The Rear Brake Calipers May Not Fully Release & Cause Brake Failure.
Steering Knuckles Have Been Incorrectly Manufactured & May Reduce Steering Control Id No's J145736 To J153237.
Strength Of Safety Catch Is Not Sufficient To Halt Cabin From Lowering Completely Should A Hydraulic Failure Occur.
Rake Pedal Pin & Front Suspension Strut Bolt Omitted Causing Brake/steering Failure & Pvs Incorrectly Fitted.
The Accelerator Cable May Contact Left Hand Front Brake Pipe & Eventually Wear A Pin Hole Resulting In Brake Failure.