Every safety recall published by the Australian government, searchable and filterable.
The stone chipping resistant agent sprayed to the underside of the vehicle may have been applied where rear torsion axle retaining bolts are located.
The amount of adhesive agent applied between the outer ring and torsional rubber damper of the crankshaft pulley may be insufficient.
The wire harness was not routed in the correct location.
Non compliant brake pads may have been incorrectly installed on the vehicle.
The evaporative valve purge harness may not be secured properly and could lead to the harness becoming damaged.
Early wear on the auxiliary belt tensioner.
Early wear on the auxiliary belt tensioner.
The electric power-assisted steering may disengage. The mechanical steerability of the vehicle will be maintained at all times, however.
In isolated cases, the second stage of the front passenger airbag may not deploy as designed. The first stage of the airbag will in all situations remain fully operational, however…
Due to insufficient tensioning of the steering bevel lock-nut on affected trucks within the VIN range, there is the possibility that the lock-nut may loosen.
Early wear on the auxiliary belt tensioner.
On some Fiat Scudo vehicles, the wiring for the power steering electric pump might interfere with one steel edge of the left front wheel arch and become damaged due to a possible l…
Incorrect engine management calibration.
There is a possibility that the battery's negative cable is incorrect in length.
The side stand may bend or break under heavy load while the bike is resting on it.
In some cases, the spare wheel support device might break due to incorrect operation.
Insufficient clearance between the seat belt and seat base cushion.
It is possible that one of the circlips that retain the piston pins within the pistons has been incorrectly installed.
Due to the piping design, which was changed from 2008 model onwards, the rear brake reservoir hose is able to repeatedly contact the speed sensor guide and a sharp edge on the rear…
In some cases there is a possibility of having the mounting bolts of the number plate holder coming loose.
The cover panel on top of the engine can chafe against the vacuum pump and the brake booster, and in some cases this condition may lead to a vacuum leak in the brake booster system…
The Simard steering double knuckle arm on certain Sterling 8X4 front axles may not have been manufactured to the correct material specification and could fracture under normal load…
In the electric power steering rack and pinion assembly of affected vehicles, if the steering wheel is frequently turned to the full lock position with high force, there is the pos…
On some X240 vehicles, it is possible that the lower section of the steering column may come into contact with the front-right hydraulic brake pipe due to the small clearance betwe…
On some X240 vehicles, it is possible that the lower section of the steering column may come into contact with the front-right hydraulic brake pipe due to the small clearance betwe…