Every safety recall published by the Australian government, searchable and filterable.
In certain rare instances where the vehicle is used under full load conditions and cornering at high lateral acceleration, a crack may occur on the spoke of the alloy wheel.
The steel balls which are used to seal the processing bores of the valves may not be secured properly in the housing and may come loose.
There may be a leakage from the steering gear. It is most likely that the leakage will occur gradually and slowly drain the power steering oil, generating noise and gradually decr…
A fuel line supply line may be incorrectly manufactured which may lead to a fuel leakage.
Under some special conditions of use, upon instrument panel switch-on, the hands free control unit could cause the failed disengagement of the electronic steering lock.
There is an internal non-conformity in one of the electric parking brake cables.
There is an internal non-conformity in one of the electric parking brake cables.
The cabin seat belt bolts (sash anchor bolt & outboard lap anchor bolt) for the driver and passenger may not have been tightened to the required torque.
On eligible units, there is a possibility that the ignition coil mount bracket may fracture as a result of repetitive large impacts from jumping etc.
Pipes have been supplied with zinc-nickel plating that does not meet the corrosion protection requirements of Jaguar's engineering specification.
The rear seat backrest may not remain in the latched position (upright) during vehicle motion.
It is possible for the rear brake calliper hose to come into contact with the rear suspension spring which, over time, could wear the hose.
A rectifier diode used in the DC-DC converter may have been damaged during manufacture which could lead to an internal short circuit during customer usage.
Some regulator/rectifier assemblies were produced with insufficient adhesion between the power module and the rectifier case. Due to the insufficient adhesion, heat generated from…
The sliding portion between the lost motion spring and rocker arm is not sufficiently lubricated for high surface pressure setting at low engine speed, potentially causing breakage…
The internal dimension of the press fit collars may be oversized, reducing the locking capacity of the collar.
The engine drive belt tension adjuster pulley, which maintains tension of the engine drive belt for various ancillaries, has been found to potentially have an incorrectly manufactu…
The front fender liners on the vehicle may detach or sag allowing the fender liner to contact one or more of the brake tubes.
In the event of emergency braking or vehicle collision, the rear seat assembly may not remain in the locked position and may move forward with the motion of the vehicle.
It is possible that a loss of fluid may develop at the connection between the high pressure line and the power steering pump. The gradual loss of fluid is generally followed by a w…
The manufacturing process to attach the wiper arm to the spindle was insufficiently controlled such that the specified torque was imparted on the fixing.
A fabrication defect has resulted in misplacement of the bolt hole on the steering shaft.
The adhesive strength between the left and right rear vent window and its forward mounting hinge may be insufficient.
It is possible that the rubber seal portion at the rear end of the brake master cylinder may turn and brake fluid may leak from the seal portion, causing the warning light to be il…
A concern affecting the intelligent power distribution module (IPDM) relay has been identified. There is a possibility that the ignition relay contacts in the IPDM may become conta…