Every safety recall published by the Australian government, searchable and filterable.
In certain vehicles, the Owner's Manual supplied contains an error relating to the description of the rear door child lock function where the locked and unlocked positions are inco…
There may be an internal leak within the hydraulic clutch system on affected motorcycles. If this leak continues for an extended period, the clutch master cylinder reservoir could…
Air suspension systems may contain wrong material for the Leaf Stopper. While driving, the Stopper and Leaf come into contact when travelling over a speed bump, and the load may no…
The headlights' high beam may remain permanently activated, or may not automatically dim, where the Adaptive High Beam Assist is used.
The engine hose may be incorrectly installed, resulting in oil leaks.
Some RAM 1500, 2500 and 3500 vehicles may have a defective tailgate latch.
Incorrect operation of the ASC safety system software may cause safety features to disable momentarily. There are several vehicle safety features controlled by the ASC safety syste…
Mitsubishi’s Forward Collision Mitigation (FCM) uses a system of intelligent sensors to scan for obstructions ahead and issues a visual and audio alert where there is a danger of c…
The drawbar of the Ezytrail K Series MK1 Albany Range, Lincoln Range, Portland Range and Stirling Range products was supplied with a weld attaching the top of the drawbar to the ma…
The towbar label has the incorrect load ratings specified. This may result in the towbar being used to tow objects above it's maximum weight.
Gas-filled shock absorbers on the rear axle may have an incorrect weld on the lower securing eye of the shock absorber.
The top tether anchorage point at the centre position of the rear seat bench may be missing.
The front windscreen wiper motor venting device may allow water to enter the wiper motor, causing corrosion and motor failure.
A fault with the halfshaft assembly resulting in loss of power or inability to PARK the vehicle. The vehicle can crash without prior warning and cause vehicle occupants or bystande…
On affected vehicles, the cooling strategy and maximum temperature alert might cause engine overheating.
The engine may not restart after being switched off.
If the engine overheats this can result in an oil leak, leading to loss of engine oil.
Vehicles were manufactured with front axles that do not have the correct width requirements.
A low cell voltage condition in the battery pack may cause the vehicle to experience a reduction or loss of forward movement, or not start. A warning light will be shown on the in…
Due to a possible electrical connection failure to the cars main battery power cable where it connects into the vehicles fuse box, the car may lose power to several electrical syst…
In certain operating conditions vehicles equipped with a SPL250 driveshaft and specific Meritor rear axles may experience rear axle yoke failure potentially causing the driveshaft…
Faulty software may cause the fuel pump to stop working while the car is in motion.
The propeller shaft on affected vehicles has a weld seam connecting the propeller shaft head with the universal joint to the propeller shaft, including a sliding piece. This weld…
The CVT controller may fail to control the oil pressure correctly.
The CVT controller may fail to control the oil pressure correctly.