Every safety recall published by the Australian government, searchable and filterable.
Due to a software issue, the integrated control module software may cause system errors. This can result in a sudden loss of motive power.
Due to a manufacturing defect, the Electric Parking Brake (EPB) may not operate as intended and could remain partially engaged whilst driving. If this occurs, it could overheat lea…
Due to a manufacturing defect, the fuel tank cap seal may crack. If this occurs, fuel may leak and in the presence of an external ignition source could result in a vehicle fire.
Due to a manufacturing defect, the fuel tank cap seal may crack. If this occurs, fuel may leak and in the presence of an external ignition source could result in a vehicle fire.
The brake rotor stud holes may not have been manufactured to specifications causing assembly variance of the hub and rotor. As a result, the wheel nuts may not retain sufficient to…
Due to a manufacturing defect, the steering gear’s bearing bushing may become detached from the steering assembly. If this occurs, the vehicle may experience a sudden loss of stee…
Due to a manufacturing defect, there is a possibility of engine machining debris contamination within the engine. This could lead to potential engine knocking, rough running and/or…
The high voltage battery may short circuit if charged over 80 percent capacity. If this occurs, the battery could overheat and lead to a vehicle fire. Our ongoing and intensive fie…
The affected vehicles are provided with supercharger upgrade kits that include a Powertrain Control Module (PCM) that may experience a software error and disable functional safety…
Due to a manufacturing issue, the modules installed in the high voltage battery may be defective. During charging a thermal overload could result in a vehicle fire.
The affected trailers are provided with wheel nuts that may not be compatible with the spare tyre. As a result, if these nuts are used on the spare tyre, the clamping force between…
Due to a manufacturing issue, the wiring harness to the key switch may have been routed incorrectly and could break. As a result, the vehicle may experience loss of propulsion whil…
In the event of collision, the inner side of the cushion frame may move forward and downwards much further than expected, inadvertently contacting the unlocking lever and then the…
Due to a software issue, if the driver does not have their hands on the steering wheel for an extended period, the brake jolt triggered by the Emergency Assist (EA) or Travel Assis…
Due to a manufacturing defect, the 12-volt battery vent may not operate as intended. As a result, under certain driving conditions such as high temperatures toxic gases may leak in…
Due to a manufacturing defect, the wiring harness connecting the trailer lighting may not have been assembled to specifications. As a result, the faulty connection may generate exc…
Due to a manufacturing defect, the wiring harness connecting the trailer lighting may not have been assembled to specifications. As a result, the faulty connection may generate exc…
Due to a manufacturing defect, the wiring harness connecting the trailer lighting may not have been assembled to specifications. As a result, the faulty connection may generate exc…
Due to a manufacturing defect, excessive heat from the exhaust may soften the paint around the gear change pivot bolt. If this occurs, the bolt may become loose and the gear shift…
Due to a manufacturing issue, the wiring harness between the door pressure sensor and the airbag control unit has an incorrect connector pin allocation.
The seat brackets in the rear cabin do not comply with Australian Design Rule (ADR 03/04) - Seats and Seat Anchorages requirements and may fail.
Due to a software issue, the Instrument Panel Cluster (IPC) may fail to illuminate the visual and audible warnings for seat belt, vehicle speed, fuel level, engine status and other…
Due to a manufacturing defect, the fuel pipe may chafe against the support bracket and become damaged. If this occurs fuel may leak, potentially resulting in loss of motive power w…
Due to a manufacturing issue, the fitting connecting the delivery hoses to the lift axle spring brake may not have been tightened to the sufficient torque and could become loose. T…
Due to a manufacturing issue, the rear-view camera may not display the rear-view image whilst reversing as intended.