Every safety recall published by the Australian government, searchable and filterable.
The curtain airbag, seat belt pre-tensioner and side impact sensor circuits have been incorrectly orientated in the main wiring harness.
Water may travel along the heated power mirror wiring harness and into the heated power mirror electrical connector. This can cause corrosion inside the heated mirror connector and…
The fuel pressure sensor of some vehicles may be insufficiently tightened to the fuel rail, and may loosen gradually due to heat and vibration of the engine. In some cases, fuel le…
The glow plug control module that aids cold engine start up can be adversely affected by wet conditions due to its location, low in the engine compartment
The Frequency Operated Button Ignition Key (FOBIK) may stick between the 'START' and 'RUN' position. This may result in the loss of certain electrical features. For example the de…
The Steering Column Control Module may experience electrical interference (static) in the SCCM printed circuit board communication circuit. This unintended electrical interference…
Engine oil leaks have occurred from certain oil cooler hoses in a small number of 2ZZ powertrain Elise, Exige and 2-Eleven vehicles and 2GR powertrain Evora vehicles manufactured b…
The driver side airbag inflator may have been incorrectly assembled.
The front airbags may not inflate correctly in the event of an accident.
Due to issues with the assembly process, certain fixings may become loose. This may result in the Front End Accessory Drive belt slipping or falling off, the Power Assisted Steerin…
The vehicle Weight Certification label has the incorrect value for Gross Vehicle Weight Ratings (GVWR).
The battery lead may be pinched between the seat base and the seat bracket. Over time the insulation of the battery wire lead may be worn away.
There is a possibility that the sealing property of the gasket between the fuel pressure sensor and the fuel delivery pipe could become degraded over time and may result in a fuel…
Certain vehicles may experience an unintended change in ignition switch position while driving.
The end cap on the right-hand fuel delivery pipe in the engine may have been insufficiently welded, in this condition, fuel could leak from the fuel delivery pipe.
Internal wiring may be fitted in a manner that could affect the operation of the driver’s side airbag if deployed.
The vehicle may illuminate both the low and high beam headlamp elements when the high beam mode is selected. The headlamps will then draw current in excess of the design specifica…
These motorcycle models may develop a tear in the primary cup (seal) of their Hydraulic Clutch Master Cylinder piston.
These motorcycle models may develop a tear in the primary cup (seal) of their Hydraulic Clutch Master Cylinder piston.
Due to a wiring concern the heater shutoff valve may overheat.
Under certain conditions an internal short circuit in the cooling fan module can lead to a failure and combustion of the external cable insulation. Secondary short circuits can the…
The transmission mount on a small number of these vehicles may develop a fracture.
Some Jeep Grand Cherokee vehicles may allow fuel leakage from the fuel tank during low speed collisions.
Some Jeep Liberty vehicles may allow fuel leakage from the fuel tank during low speed collisions.
The vehicles may have been built with an incomplete weld on the seat hook bracket assembly, for either front seat.