Every safety recall published by the Australian government, searchable and filterable.
Moisture may enter the diesel fuel filter heater at the electric contacts.(Note: The diesel fuel filter heater unit only operates at tempratures below -1° Celcius.)
The fuel return pipe fitted to the vehicle could separate and allow fuel to leak under the vehicle.
There is the possibility that the fuel supply line can come into contact with the heat shield in the engine compartment. This could cause damage to the fuel supply line, which in i…
The power steering return line may fail due to incorrect routing of the power steering cooling line. Should this condition occur, it may result in a sudden drainage of power steeri…
On affected models, the ground joint connector of the wire harness could overheat and become deformed, possibly causing an intermittent ground wire connection.
There is a possibility of contact between the electric harness and its surroundings if the protective sleeve is damaged.
On some vehicles fitted with a V6 3L HDi 240hp FAP engine, during harsh and prolonged braking, there is a risk of incorrect interpretation of engine oil level information.
The fuel tank may leak from cracks at the spot weld(s) on the side mount tabs due to stress caused by excessive clearance between the fuel tank and the frame-mounted rubber damper.
In the SRS side airbag and curtain shield airbag system of the involved vehicles, due to the incorrect side airbag sensor polarity, the G-force threshold to detect a side impact ma…
The defective riser / clamp assemblies do not provide sufficient clamping force and may allow the handle bars to rotate in the riser assemblies.
Prolonged high under-bonnet temperatures may cause the power steering hose to deteriorate prematurely and may cause the hose to crack and leak power steering fluid.
The front door wiring harness on your vehicle may fatigue and break. Broken wires could interrupt circuts for the side impact sensor(s), resulting in the illumination of the airba…
There should have been a glass splash back fixed to the kitchen wall to protect the wall from heat generated by the cooker.
On vehicles fitted with these kits, the Body Control Module (BCM) has a case that may not be sealed sufficiently to prevent water intrusion. Water intrusion of the BCM may lead to…
The front power seat stop lugs may not be assembled according to specification.
The front power seat stop lugs may not be assembled according to specification.
There may be an electrical short circuit in the driver's airbag clockspring wiring connector. If the deviation occurs the supplemental restraint system lamp (SRS) will be permanent…
A situation may occur where the rider may need to exert a force greater than expected to turn the handlebar in order to correct the vehicle's trajectory. At this increased level of…
The chain guide bracket is not welded properly on the swingarm. This could result in weld cracking which may cause the drive chain to derail from the rear sprocket.
When bringing a vehicle equipped with the SE5 semi-automatic transmission to a full stop, the clutch may remain engaged stalling the engine. Once the engine is stalled, it could be…
A manufacturing defect in the fuel pressure line may result in a fuel smell and/or fuel seepage.
Certain 2010 model year Subaru Liberty and Outback vehicles may experience a wiring fault within the steering roll Connected.
The transmission fluid in your vehicle may overheat under certain driving conditions. Continuous operation under these conditions may cause the transmission fluid to boil over and…
A manufacturing defect in the fuel pressure line may result in a fuel smell and/or fuel seepage. Since the fuel lone is working under a constant pressure, some seepage can, within…
Isuzu Motors Japan have identified that the fuel cut off valves may not seal to their design intent. This is due to a variation in tolerances during production.