Every safety recall published by the Australian government, searchable and filterable.
The turn signal speed doesn't change when a globe is not working.
There is a risk of insufficient weld penetration and/or overgrinding of the weld on the suspension trailing arm elbow resulting in reduced material thickness.
The front bumper bar lower trim finisher may not have been properly secured.
1. The current Head Light Control Unit (HLU) software may cause the LED headlight to reboot while in operation.2. The instrument dashboard may lose information or not display all i…
Water may enter between the hood and windshield and cause the front wiper link ball joint to corrode, possibly resulting in the wiper link separating and the wipers becoming inoper…
The screw joint holding the spring leaf attached to the spring anchorage might become loose, broken or lost during driving.
The cab power and ground cable terminals (eyelets) may crack and eventually fail where the terminal attaches to the cab pass through plate.
In certain Isuzu NQR series vehicles, the bolts associated with the rear left side wheel bearing nut (the rear wheel bearing hub locking bolts) may not have been properly torqued d…
Due to improper engine software, EV software and spark plug specification, the petrol engine may shut down unexpectedly. This will limit the vehicle to EV drive mode only, with no…
The short rubber hose section of the intercooler pipe may not be in conformance and could break during the normal use of the vehicle.
The dust gaiter/push-rod assembly in the brake master cylinder is defective.
A fault in an earth connection on the ESC control unit may occur due to excessive thermo-mechanical strain on components in the control unit.
The AEB software for vehicles without a tachograph has not been downgraded.
Improper Cell Motor Unit (CMU) judgment of changes to the temperature and voltage of the main traction battery can occur when the vehicle is rolling backwards.
The chemical mix ratio in some initiators used in the manufacture of seatbelt pre-tensioners may not meet specification, which may cause the initiator to malfunction. In the event…
Bolts holding the inflatable curtain in place could be affected by a manufacturing error that may cause the bolt head to detach, subsequently not fully securing the inflatable curt…
The thermal overload within the ABS control unit can interrupt the current flow to the ABS control unit. This would stop the ABS from functioning correctly and would illuminate the…
The thermal overload within the ABS control unit can interrupt the current flow to the ABS control unit. This would stop the ABS from functioning correctly and would illuminate the…
The fuel tank ventilation line may not be correctly located. If the ventilation line rubs against the vehicle, it may wear through.
Certain Volkswagen Golf models of a limited production period may have tyre placard labels displaying the wrong specifications for the vehicle.
The camshaft could potentially crack while the vehicle is in use due to a non-compliance of the material during production process.
The reverse camera screen in the infotainment unit may freeze when the gear selector is in reverse.
The electrical wiring harness for the front windshield wiper motor has not been routed correctly. Due to the movement of the windshield wiper linkage the electrical wiring harness…
The instrument panel brace may interfere with the wire harness. This interference may cause the wire harness to become damaged by the edge of the brace, causing a short circuit.
There is a possibility that an intermittent Output Shaft Speed Sensor failure may result in an unintended downshift into first gear.