Every safety recall published by the Australian government, searchable and filterable.
Under certain operating conditions, front brake hoses may develop a brake fluid leak.
After starting, if the vehicle is only driven at low speed with minimal or no throttle opening, an increased brake pedal effort may be required on the first braking application bec…
Long term laboratory durability testing has revealed that the lower ball joint of the front struts on certain vehicles with ABC suspension could fracture after very high mileage wh…
On affected vehicles the rear brake shoe holder locating pin may come loose.
If the front parking sensors function “Stops and Go” is active, it may happen that the seat belt warning buzzer does not advise if the seat belts are not engaged.
Due to the shape of the rear brake pedal, small stones or other road debris can become trapped between the brake pedal and the rear master cylinder actuating rod. This can overheat…
On affected vehicles the brake pedal could be stiff when pressed for the first few times after starting the cold engine.
On eligible units, the bore of the throttle body assembly may have a micro-crack where the air cleaner duct attaches due to improper casting mold set up. The crack can develop duri…
On some eligible units, the main harness may chafe against the frame and cause the engine to stop running. This may create the potential for an accident.
On some eligible units, improper tightening of the muffler mounting bolts can cause the bolts to unscrew by vibration, resulting in the muffler disconnecting and falling off, creat…
It is possible a child restraint anchor fitting may not have been installed in the centre seating position during the manufacturing process. If the child restraint anchor fitting w…
If the independent trailer handpiece is actuated while the vehicle is in cruise control, the cruise control will not cutout and the engine will continue driving. After the trailer…
It has been established that micro-cracks may have been introduced in the bent portion of the rear axle U-bolt during the manufacturing process. When vehicles fitted with the affec…
On 2.4 litre single cab and GL model cab chassis vehicles fitted with sports seats, the compliance plates may show an incorrect seating capacity of 3. The correct seating capacity…
On certain Land Cruiser 200 model vehicles where fitted with Toyota genuine bull bars, especially if they operate for long periods in harsh usage conditions such as corrugated road…
There have been several occurrences where the support bracket on the oil filler tube of the Caterpillar C12 engine in the International 7600 has failed causing part of the bracket…
It has been found that some reinforcement plates, which have to be installed on the side rail of the frame, were missing. Due to insufficient strength of the frame, due to the miss…
In some cases a gas cock has not been fitted to the gas line leading to the BBQ.
The drain hose for the climate unit can get clogged. This may lead to poor or no water drainage, which may result in the short circuit of the Positive Temperature Coefficient (PTC)…
Due to the improper location of an instrument panel wiring harness connector on affected trucks, condensed water from the air conditioning system may infiltrate the connector.
The welded portion of the lower rear shock mount may crack from vibration and impacts generated from bumps while riding.
Installation of the Isringhausen driver's seat with integrated seat belt prior to the vehicle's delivery was not performed in accordance with the specified installation procedures.…
Some of the vehicles may have received a propeller shaft with insufficient high frequency heat treatment. Due to inadequate high frequency heat treatment on the base of the propell…
Reports of frame cracking and/or breakage behind and below the steering head tube.
On certain Yaris NCP90, NCP91 and NCP93 vehicles, an insulator pad was incorrectly installed underneath both of the front seat belt retractors (equipped with seat belt pretensioner…