Every safety recall published by the Australian government, searchable and filterable.
The bolts used to secure the housing and sprocket of the intake side Variable Valve Timing gear assembly could become loose due to abnormal impacts generated within the gear assemb…
Due to variations in the circuit characteristics of the Intelligent Power Module, higher operating temperatures may result in internal solder degradation.Eventually this will cause…
The ABS unit is required to be checked for a possible foreign particle, which may become trapped in either the inlet or the outlet valve.
When the gear selector is set to the “park” position, the parking pawl may not engage and therefore the parking mechanism may not operate properly. In this case (assuming the parki…
A manufacturing fault has been found with the double connecting rod.
It has been identified that the heater blower motor may jam, causing the resistor fuse to possibly over-heat and cut out.
It has been identified that the heater blower motor may jam, causing the resistor fuse to possibly over-heat and cut out.
The potential defects or combination of defects are as follows:(1) The Electronic Power Steering computer may fail, causing the EPS warning lamp to illuminate and in the worst cas…
The potential defects or combination of defects are as follows:(1) The Electronic Power Steering computer may fail, causing the EPS warning lamp to illuminate and in the worst cas…
The potential defects or combination of defects are as follows:(1) The Electronic Power Steering computer may fail, causing the EPS warning lamp to illuminate and in the worst cas…
The front brake air hoses are too long. This may allow the hoses to make contact with other components damaging the hoses.
When the brake pedal is pressed, the master power booster body can be displaced and the seal-ability of the diaphragm can be reduced. If this occurs brake assist power is reduced,…
The rear compartment seat brackets may not sufficiently interlock to make it secure.
The handbrake handle may not fully engage.
The snap-ring connecting the oil hose at the transmission oil cooler may be missing.
The snap-ring connecting the oil hose at the transmission oil cooler may be missing.
A selection of Rolls-Royce Ghost models have been identified as having an incorrect software installation, possibly resulting in the fuel tank ventilation system being deactivated.
Trucks may seep or leak diesel fuel from the linkage pipe at the upper or lower fuel port on the diesel fuel supply pump.
An incorrect warning label has been attached to Hyundai i20 vehicle jacks.
The attachment points on the Nissan genuine accessory towbars can create excessive stress upon the chassis frame rails over time. As a result, cracks can occur at the ends of the r…
Due to production deviation the tightening torque may be too low on the front torque rods of the front axle with air suspension.
The indicator stems need to be replaced due to incorrect material composition causing the turn indicator stems to fracture after a short period of time.
On all affected vehicles the cooling fan can continue to run even when the ignition is switched-off.
Isuzu Motors Japan have identified that the Meritor Axle Lock Nut Locking Tab may have been misassembled and this may, in extreme cases, cause the wheel to come loose from the axle…
The air tank securing brackets may develop cracks and this may result in air tanks falling from the vehicle.