Every safety recall published by the Australian government, searchable and filterable.
Due to a software issue in the Engine Control Unit (ECU), the Selective Catalytic Reduction (SCR) system may not operate as intended. If this occurs, the instrument panel warning l…
The Diesel Particulate Filter (DPF) may crack due to overheating. If this occurs the DPF may not operate as intended resulting in an increase of tailpipe emissions.
The Diesel Particulate Filter (DPF) may crack due to overheating. If this occurs the DPF may not operate as intended resulting in an increase of tailpipe emissions.
Due to a software issue with the Engine Control Module (ECM), the vehicle may release air pollutants that exceed the standards set in Australian Design Rule (ADR) 80/03.
Incorrect compliance and data labels are fitted on the left and right hand front door openings. The labels do not match the Vehicle Identification Number (VIN) stamp in the engine…
A soot sensor component may not have been installed as intended. As a result, the vehicle may release air pollutants that exceed the standards set in Australian Design Rule (ADR) 8…
The tool to mechanically open the spring-loaded parking brake chamber was not supplied with the vehicle.
Due to a manufacturing defect, the spline teeth of the windshield wiper arms may deteriorate and could result in loss of wiper function.
The spark plugs fitted in vehicle specified do not comply with Australian Electromagnetic Compatibility (EMC) standard AS/NZS CISPR-12.
Due to a software fault the Electronic Control Unit (ECU) can be reset when the vehicle switches to electric drive. This will erase stored vehicle fault codes and turn off the chec…
Due to a manufacturing defect, certain vehicles may develop a fracture to the mounting bracket at the base of the seat. As a result, the seat base may shift within the seat suspens…
Due to a manufacturing issue, the cab mounting brackets have not been tightened to the designated torque. This could cause the cab lock down mechanism to become loose.
Due to a manufacturing issue, the vehicle type approval labelling required to be displayed on the engine was not fixed to the vehicle.
The ‘Stand Assist’ system which keeps the bike upright when stopped may not release immediately after deactivation as intended. This may prevent the rider from steering, resulting…
The handlebar on affected motorcycles may have a weld quality issue that could lead to separation between the inner and outer sections of the handlebar. This could result in a loss…
Due to a manufacturing defect, when the ignition is switched off it may cause a surge within the Electronic Control Module (ECM). This may result in the rider being unable to resta…
Due to a manufacturing issue, the connection of the horn to the frame of the motorcycle could become loose and may detach. As a result, it could fall downwards and prevent the ride…
If the rear fog lamp is switched ON after the ignition has been switched OFF and the driver’s door opened, the audible warning will not sound.
During manufacture the incorrect VIN number was stamped onto the compliance plate.
Due to a software issue, the rear turn signal lights may be slightly illuminated when not in use and brightly flash when operating.
The ‘Stand Assist’ system which keeps the bike upright when stopped may not release immediately after deactivation as intended. This may prevent the rider from steering, resulting…
The compliance label on some trailers may have been printed with an incorrect Aggregate Trailer Mass (ATM) and tare mass that is lower than the actual mass of the machine. In addit…
The wiring harness of the fast flash bulb out warning indicator on the dash maybe defective. As a result, the warning light may be triggered even when no bulbs have failed.
To meet the requirements of European towbar regulation ECE 55-01, it is necessary to apply an ECE label to the towbar when fitted to a vehicle. This label was not affixed to the to…
To meet the requirements of European towbar regulation ECE 55-01, it is necessary to apply an ECE label to the towbar when fitted to a vehicle. This label was not affixed to the to…