Every safety recall published by the Australian government, searchable and filterable.
Information Concerning Seat Belt Operation, Emission Control, Tyre Selection And Vehicle Jack Use Omitted.
There May Be A Crack In The Fuel Tank.
Camber Kits Have A Suspected Defect.
Kenworth Trucks Manufactured With An Airglide 100 Rear Axle Suspension May Contain A Defective Stabilizer Bar.
Incorrect Fitting Of Seat Belt May Cause It To Be Inadvertently Released.
Contact Between Steering Shaft And Brake Pipe Could Result In Loss Of Rear Brakes.
Steel Wheels Distorted During Vehicle Plant Assembly, Which May Result In Fracture Of Wheel Studs.
Steel Wheels Distorted During Vehicle Plant Assembly, Which May Result In Fracture Of Wheel Studs.
Rear Brake Hoses May Be Incorrectly Positioned.
Rear Brake Hoses May Be Incorrectly Positioned.
Weld Holding The Tongue Plate To The Towbar May Fail Causing Load To Detach From Vehicle Without Warning.
Malfunction May Occur On Either Front Or Rear Turn Signal Lamps.
Malfunction May Occur Within The Electrical Isolation Switch.
Check Valve In The Dual Compartment Air Reservoir May Not Seat Correctly.
Leak May Occur If A Washer In The Primary Seal Becomes Dislodged.
Front door latch screws may loosen or fall out.
Defect May Exist In Rocker Arm Bracket Which May Result In Bracket Breaking Off The Frame And Possible Loss Of Control.
Swelling Of The Region Of The Fuel Tank Inlet May Result In A Detrimental Effect On The Rubber Gasket.
It Is Possible That Any Item May Foul The Safety Latch And Withold It From Maintaining A Positive Catch.
The Rh Side Rider Footrest Mount Could Fracture If Subjected To Heavy Impact Loads.
The Upper Mounting Bolt On The Front Brake Calipers Might Develop A Fracture Causing The Front Wheel To Lock Up.
International N-series Vehicles With Air Operated Parking Brakes May Have A Fault In The Brake Circuit Plumbing.
Driveshaft Failure When Vehicle Is Driven At Speeds In Excess Of 130 Kph.
Pedal Springs May Fail Causing Pedal To Go To Full Throttle Resulting In Loss Of Control Of The Vehicle.
Instrument Panel Wiring Loom May Become Abraded On The Lower Edge Of The Pedal Support Bracket.