Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing issue, the front and rear window glass may have insufficient bonding to the vehicle’s body.
Due to a software issue in the Integrated Charging Control Unit, the auxiliary 12 Volt battery may not charge as intended, resulting in battery drainage and loss of motive power.
Due to a software issue, the Integrated Charging Control Unit (ICCU) may develop an internal fault causing a warning light to illuminate on the instrument cluster and the 12 Volt b…
Due to a software issue, the headlamp high beam setting may not operate as intended. This could result in reduced or poor visibility.
The electrical power steering control unit back-up software may not operate as intended. In the event of a failure of the power steering control unit, this could result in a loss o…
Due to incorrect software being installed in the vehicle, the ‘fail-safe’ mode may not operate when oil pump faults are detected in the dual clutch transmission. If this occurs it…
Due to a vehicle processing error, incorrect fuel consumption and emission data has been provided on the fuel consumption label.
The base area of the vehicle jack may not meet the minimum size requirements of the Australian Consumer Product Safety Standard. If a non-compliant vehicle jack is used, it could b…
Due to a manufacturing issue, the driveshaft may brake under load. If this occurs, it may lead to a sudden loss of motive power.
Due to a manufacturing defect, the driveshaft may break under load. If this occurs, it may lead to a sudden loss of motive power.
Due to a manufacturing issue, the threaded nut securing the 48 Volt wiring harness under the driver seat may become loose. If this occurs, it could result in higher than normal ele…
Due to a manufacturing defect, the vehicles are missing a hand rail adjacent to the service door as required by Australian Design Rule (ADR) 58/5 – Access to and from omnibuses. Ad…
Due to a manufacturing issue, an incorrectly routed power cable could contact a ground stud of the vehicle and short circuit. This may increase the risk of overheating and a vehicl…
Due to a manufacturing issue, the side curtain airbags may be fitted with a faulty gas generator. As a result, the airbag may not deploy as intended.
Due to a manufacturing defect, the bracket retaining the engine control unit could interfere with the vehicle’s wiring in the event of a collision, causing a short circuit resultin…
This is a re-notification of REC-000585.Due to an improper manufacturing process, a component within the fuel pump could swell causing the fuel pump to become inoperative.
Due to a defect during assembly, incorrect fasteners may have been installed on the steering linkage joints and could become loose over time. If this occurs, the vehicle may experi…
This recall is a re-notification for REC-005700.Due to an incorrect service diagnostic tool and software update, the affected vehicles remain with the safety defect. As a result, v…
Due to a manufacturing defect, the fuel pump impeller may swell and cause the fuel pump to stop working. If this occurs, the engine could stall resulting in a loss of power.
Due to a software issue, the radiator fan may exceed its maximum operating temperature limit leading to a malfunction of the coolant fan motor. If the rider ignores the instrument…
The vehicle may have been fitted with side direction indicator lamps that do not comply with the Australian Design Rule 13/00 – Installation of Lighting and Light Signalling Device…
Due to a manufacturing defect, the fuel pump impeller may swell and cause the fuel pump to stop working. If this occurs, the engine could stall resulting in a loss of power.
Due to a manufacturing defect, the high voltage battery may experience a thermal overload if charged over 80 percent capacity. If this occurs, the battery could overheat and lead t…
Due to a design issue, the vehicle headlamp assembly supplied as a component may exceed the illumination standard required by the Australian Design Rule 46/00 – Headlamps.
Due to a manufacturing defect, air present in the front brake system may cause a loss in hydraulic brake line pressure. This may result in loss of braking performance.