Every safety recall published by the Australian government, searchable and filterable.
Due to a software issue, the passenger side folding door control unit may have been overwritten with incorrect parameters. As a result, if an obstacle is detected during automatic…
Due to a calibration issue within the Vehicle Control Module (VCM), when driving at low speeds the vehicle may falsely detect reflective objects such as metal walls, barriers or si…
Due to a software error, the infotainment unit screen may enter a test mode during start-up of the vehicle. This may prevent key information such as the vehicle's speed from being…
Due to a manufacturing defect, the side curtain airbag may inflate without warning.
Due to a manufacturing defect, the sealing of the high-voltage battery housing may be insufficient, allowing moisture to enter into the battery compartment. This may cause the vehi…
Due to a manufacturing defect, the driver’s side B-pillar may not have been welded to the required specification. As a result, the reinforcement in pillar may become loose over tim…
Due to a manufacturing defect, the high-voltage battery housing in affected vehicles have an insulation fault. This may cause the vehicle's battery to turn off when driving resulti…
The brake lamp switch assembly may have been installed incorrectly, if the hill starting assist device (EZGO) is activated, there may be a large time lag until the brake lamp light…
The courtesy lamps fitted in the vehicles do not comply with the requirements set out in the Australian Design Rules (ADR).
Due to a software issue within the Body Control Module, the parking lamps and number plate lamp may not illuminate when the vehicle is travelling below the speed of 10 kilometres p…
Due to a manufacturing defect, over time and under certain conditions friction and excessive movement in the steering gear could result in a loss of steering control.
The rear-view mirrors may extend further than the required standard set under Australian Design Rule 14/02 - Rear Vision Mirrors.
Due to a manufacturing issue, the cell modules installed in the high voltage battery may be defective. A short circuit could cause a thermal overload and result in a vehicle fire o…
Due to a manufacturing defect, the passenger airbag may tear during deployment. This could cause hot gases to escape from the airbag at high speed and result in insufficient protec…
Due to software settings, if a vehicle occupant places an obstruction such as a body part between the frame and glass when the sunroof is closing, it may not reverse until signific…
Due to a manufacturing defect, the power liftgate module (PLGM) may fail due to an electrical short circuit. This may result in a vehicle fire with the ignition turned on or off.
The upper control arm retaining bolts may have been damaged during vehicle assembly. This may cause the upper control arm to detach from the steering knuckle while driving, resulti…
Due to a manufacturing defect, the vibration damper may not have been tightened to the correct torque, causing it to potentially become loose and detach from the vehicle. This coul…
Due to a manufacturing defect, spark plugs may have been damaged during assembly. This may lead to unstable idle, hesitation and possible engine stall whilst riding, resulting in a…
Due to a manufacturing defect, oil cooler lines could burst resulting in a sudden loss of oil pressure. This could lead to the engine stalling or an oil leak. An oil leak in the pr…
Due to a manufacturing defect, the front passenger side window may not have been tinted to the specifications required under Australian Design Rule 08/01 – Safety Glazing Material.…
The fixings for the fuse box cables may not have been tightened to the correct torque. This could lead to a sudden loss of motive power, loss of headlights and power assisted steer…
Due to a manufacturing error, incorrect disconnect switches and junction box mounting brackets may have been installed. This could cause the battery cable to break and result in a…
Due to a software issue with the In-Vehicle Infotainment (IVI) unit, the rear-view camera display may not display the rear camera image as intended.
Due to a software issue in the Integrated Charging Control Unit, the auxiliary 12 Volt battery may not charge as intended, resulting in battery drainage and loss of motive power.