Every safety recall published by the Australian government, searchable and filterable.
Due to improper programming of the vehicle’s trailer connection electrical control unit. The hazard lamps, reverse lamps and backup alarm may activate when the lamps are not activa…
Due to a software issue, the electric vehicle (EV) Drivetrain system may deactivate resulting in a loss of motive power.
Due to a manufacturing defect, the steering wheel earth wire may become loose. If this occurs, the driving assist functions such as hands-off the steering wheel warning or emergenc…
Due to a manufacturing issue, the lower frame rail clamp may not have been adequately secured to the rear brake line allowing the line to contact the exhaust. If this occurs, the b…
Due to a manufacturing defect, the front axle brake line hose(s) may become dislodged from the end fitting crimp. This may cause a reduction in braking performance or an unintended…
The driver side airbag wiring harness connection may become loose over time. As a result, the airbag warning light will illuminate and the driver side airbag will not deploy.
During an accident with high side impact forces, the glass display screen may shatter propelling glass fragments inside the cockpit.
Due to a manufacturing issue, the V-stay connection screws in the rear wheel suspension may become loose, causing the rear axle housing to move sideways. If this occurs, there is a…
Due to a manufacturing issue, the front passenger airbag inflator may catch on the dash panel and rupture in the event of airbag deployment.
The connection depth of the front towing point may not meet manufacturing specifications. As a result, the front tow point connection could detach from the vehicle during frontal t…
Due to a manufacturing issue, there is a possibility of insufficient sealing between the high voltage battery casing and battery cover. This could lead to moisture entering the hig…
The front windshield wipers may fail. In the event of rain this may lead to poor visibility for the driver.
Due to a manufacturing defect, the mounting position of the rear tail lamps and the rear turning indicators may not meet specification. As a result, during dark conditions, the tra…
Due to a manufacturing defect, the bonnet outer panel and inner frame may not have been bonded correctly. As a result, the bonnet outer panel could detach due to vibrations whilst…
Due to a configuration setting issue, the vehicle’s tilt sensor that detects any change to the vehicle angle relative to the ground may not activate as intended.
Due to a manufacturing issue, the seat belt pre-tensioner inflator cap may fracture when deployed in the event of an accident.
The side stand mounting bracket spring retaining pin may break. This could cause the side stand to open whilst riding and the stand sensor to switch off the engine, resulting in a…
During the manufacturing process, the Restraint Control Module (RCM) was loaded with an incorrect configuration. As a result, if an incorrect replacement part is installed in the s…
Due to a manufacturing issue, the rear shock absorber adjuster mounting bolt may break. As a result, the shock absorber adjuster could loosen and contact the rear tyre causing a lo…
Due to a manufacturing defect, the 48 Volt battery is susceptible to water ingress if exposed to moisture for extended periods. Water ingress can cause the battery to overheat whic…
Due to a potential design concern with the rear tail lights control circuit, the turn and hazard indicators lamps may not illuminate as intended.
Due to manufacturing defect, there is a possibility that the steer axle tie rod castle nut cotter pin is missing, allowing the steering arm to detach. This could lead to a loss of…
Incorrect compliance and data labels are fitted on the left and right hand front door openings. The labels do not match the Vehicle Identification Number (VIN) stamp in the engine…
Due to a manufacturing defect, some vehicles may have been manufactured without a reinforcing pin in the front windscreen. As a result, the windshield frame may move resulting in g…
Due to an installation defect, the internal fuse box wiring harness may become loose. If this occurs, the instrument cluster may fail to illuminate, internal, external lamps may sw…